User manual YAMAHA STAGE CUSTOM ASSEMBLY MANUAL

[. . . ] Also keep it in a safe place for future reference. 544. 5 HIGH +15 ­15 LOW +15 ­15 LEVEL R 10 0 MIC LINE REVERB MIC LINE LEVEL 3 4 5/6 Introduction · Is the vent on the top panel of the mixer blocked?Since inadequate ventilation can result in overheating the mixer, the power may be turned off automatically and the mixer may reset itself. · Is the LIMITER flashes continuously?If the internal power amplifier section is excessively overloaded, the power may be turned off automatically and the mixer may reset itself. The above warning is located on the bottom of the mixer and the rear of the speaker. HIGH +15 ­15 LOW +15 ­15 LEVEL The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. 10 LEVEL HIGH +15 ­15 LOW +15 ­15 10 0 10 0 R L R L 7/8 9/10 R L PHANTOM SPEAKERS R LIMITER 1 2 3 4 5 Read these instructions. [. . . ] These precautions include, but are not limited to, the following: * This applies only to products distributed by YAMAHA CORPORATION OF AMERICA. (class B) IMPORTANT NOTICE FOR THE UNITED KINGDOM Connecting the Plug and Cord WARNING: THIS APPARATUS MUST BE EARTHED IMPORTANT. The wires in this mains lead are coloured in accordance with the following code: GREEN-AND-YELLOW : EARTH BLUE : NEUTRAL BROWN : LIVE · This applies only to products distributed by Yamaha-Kemble Music (U. K. ) Ltd. Getting a more powerful sound from the speakers · Is the SPEECH/MUSIC switch set to MUSIC ( )? Power supply/Power cord · Remove the electric plug from the outlet when the device is not to be used for extended periods of time, or during electrical storms. · When removing the electric plug from the device or an outlet, always hold the plug itself and not the cord. Pulling by the cord can damage it. Handling caution · When turning on the AC power in your audio system, always turn on the device LAST, to avoid speaker damage. When turning the power off, the device should be turned off FIRST for the same reason. Consult qualified Yamaha service personnel about replacing defective components. · The illustrations as shown in this manual are for instructional purposes only, and may be different from the ones on your equipment. · The company names and product names in this manual are the trademarks or registered trademarks of their respective companies. IMPORTANT Please record the serial number of this unit in the space below. Model: Serial No. : The serial number is located on the bottom or rear of the unit. Retain this Owner's Manual in a safe place for future reference. · This applies only to products distributed by YAMAHA CORPORATION OF AMERICA. (Ser. No) As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug proceed as follows: The wire which is coloured GREEN-and-YELLOW must be connected to the terminal in the plug which is marked by the letter E or by the safety earth symbol or colored GREEN or GREENand-YELLOW. 17 Stycznia 56, PL-02-146 Warszawa, Poland Tel: 022-868-07-57 ASIA THE PEOPLE'S REPUBLIC OF CHINA Yamaha Music & Electronics (China) Co. , Ltd. 25/F. , United Plaza, 1468 Nanjing Road (West), Jingan, Shanghai, China Tel: 021-6247-2211 · Are the Equalizer controls (HIGH/LOW) set to appropriate levels? Use only the mixer's handles when removing the mixer from the speaker and when carrying the mixer Caution Outputting the signal to a main mixer · Connect a main mixer to the ST SUB OUT jack. The ST SUB OUT jack outputs the signal prior to routing through the MASTER LEVEL control. Adjust the level of output signal from the ST SUB OUT jack with the ST SUB OUT control. The ST SUB OUT control does not affect the MASTER LEVEL control. If only the L (left) ST SUB OUT jack is used, the mixer mixes the left and right signals and sends them to the jack. U. S. A. Yamaha Corporation of America 6600 Orangethorpe Ave. , Buena Park, Calif. Tel: 714-522-9011 THE NETHERLANDS/ BELGIUM/LUXEMBOURG Yamaha Music Central Europe GmbH, Branch Benelux Clarissenhof 5-b, 4133 AB Vianen, The Netherlands Tel: 0347-358 040 INDONESIA PT. Yamaha Music Indonesia (Distributor) PT. Nusantik Gedung Yamaha Music Center, Jalan Jend. 4, Jakarta 12930, Indonesia Tel: 21-520-2577 separate from the speaker. The mixer can also be used when installed in the speaker. NOTE: CENTRAL & SOUTH AMERICA MEXICO Yamaha de México S. A. [. . . ] For high-level signals (such as keyboard instruments and audio equipment), set the switch to the LINE ( ) position. Caution 6 ST SUB OUT L (MONO) / R jacks These output the mixed signal channels from 1 to 9/10, and the level is adjusted with the ST SUB OUT control. You can use these jacks, for example, to connect a main mixer. These impedance balanced jacks allow a longer cable to be connected with the use of a balanced cable. Caution To avoid damage to speakers, be sure to turn off amplifiers (or powered speakers) before setting this switch to MIC or LINE. We also recommend that you turn the MASTER LEVEL control to the minimum setting before operating the switch, to avoid excessively loud noises that could cause hearing loss or device damage. MIC LINE MIC LINE NOTE: When using a condenser microphone, set the PHANTOM switch to ON. @ PHANTOM switch If you set the switch on, the mixer supplies phantom power on to the XLR mic input jacks on the channels 1, 2. · Be sure to leave this switch OFF if the device or instrument that you are using does not require phantom power. [. . . ]