User manual YAMAHA STAGEPAS 500

[. . . ] EN 500 Owner's Manual Troubleshooting Power does not turn on Is the included power cord correctly connected to a power outlet? CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Explanation of Graphical Symbols The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Dimentions Speaker Mixer LOCK OPEN LOCK OPEN +15 +15 Unit: mm L (MONO) +15 15 REVERB HIGH +15 15 LOW LEVEL 10 0 Power shuts down suddenly Thank you for your purchase of the Yamaha PORTABLE PA SYSTEM STAGEPAS 500. The STAGEPAS 500 is a versatile, compact PA system consisting of two speakers and a mixer. In order to get the most out of your new STAGEPAS 500 and its sophisticated functions, we suggest you read through this manual thoroughly. [. . . ] Attempting to lift the device by yourself may damage your back, result in other injury, or cause damage to the device itself. Before moving the device, remove all connected cables. When setting up the device, make sure that the AC outlet you are using is easily accessible. If some trouble or malfunction occurs, immediately turn off the power switch and disconnect the plug from the outlet. Do not use the device in a confined, poorly-ventilated location. Make sure that there is adequate space between the mixer and surrounding walls or other devices: at least 30 cm at the sides, 30 cm behind and 30 cm above. If the mixer is to be used installed into the speaker cabinet, make sure to allow adequate space between the speaker and the surrounding walls or other devices: at least 30 cm at the sides, 30 cm behind and 30 cm above. Inadequate ventilation can result in overheating, possibly causing damage to the device(s), or even fire. Do not use the speaker's handles for suspended installation. Doing so can result in damage or injury. For details of products, please contact your nearest Yamaha representative or the authorized distributor listed below. NORTH AMERICA CANADA Yamaha Canada Music Ltd. 135 Milner Avenue, Scarborough, Ontario, M1S 3R1, Canada Tel: 416-298-1311 POLAND Yamaha Music Central Europe GmbH Sp. z. 17 Stycznia 56, PL-02-146 Warszawa, Poland Tel: 022-868-07-57 ASIA THE PEOPLE'S REPUBLIC OF CHINA Yamaha Music & Electronics (China) Co. , Ltd. 25/F. , United Plaza, 1468 Nanjing Road (West), Jingan, Shanghai, China Tel: 021-6247-2211 Using a single speaker You can use a single speaker. If you use a single speaker, the mixer outputs just one channel of the stereo Use only the mixer's handles when removing the mixer from the speaker and when carrying the mixer Caution signal, left or right. U. S. A. Yamaha Corporation of America 6600 Orangethorpe Ave. , Buena Park, Calif. Tel: 714-522-9011 THE NETHERLANDS/ BELGIUM/LUXEMBOURG Yamaha Music Central Europe GmbH, Branch Benelux Clarissenhof 5-b, 4133 AB Vianen, The Netherlands Tel: 0347-358 040 INDONESIA PT. Yamaha Music Indonesia (Distributor) PT. Nusantik Gedung Yamaha Music Center, Jalan Jend. 4, Jakarta 12930, Indonesia Tel: 21-520-2577 separate from the speaker. Outputting the signal for monitoring NOTE: The mixer can also be used when installed in the speaker. CENTRAL & SOUTH AMERICA MEXICO Yamaha de Mxico S. A. 09300, Mxico, D. F. , Mxico Tel: 55-5804-0600 FRANCE Yamaha Musique France BP 70-77312 Marne-la-Valle Cedex 2, France Tel: 01-64-61-4000 Connect a powered speaker to the MONITOR OUT jack. The MONITOR OUT jack outputs the signal prior When you install the mixer into the speaker, make sure to match the indentations on the speaker cabinet to the corresponding parts on the mixer, and then turn each screw from OPEN to LOCK until it clicks. to routing through the MASTER LEVEL control. Adjust the level of output signal from the MONITOR OUT jack with the MONITOR OUT control. [. . . ] If you've connected powered speakers to the mixer, turn on the power of the mixer first, then the POWER powered speakers. OFF ON ( POWER indicator This lights when the POWER switch is 5 MONITOR OUT L (MONO) /R jacks These output the mixed signal channels from 1 to 9/10, and the level is adjusted with the MONITOR OUT control. These jacks are convenient for connecting an external powered speaker for monitoring purposes. phantom power. When using phantom power, do not connect any devices other than condenser microphones to the XLR input jacks. Other devices may be damaged if connected to phantom power. [. . . ]