User manual YAMAHA STAGEPAS300

[. . . ] EN Owner's Manual Introduction Thank you and congratulations on your purchase of the Yamaha PORTABLE PA SYSTEM STAGEPAS 300. The STAGEPAS 300 is a versatile, compact PA system consisting of two speakers and a mixer. In order to get the most out of your new STAGEPAS 300 and its sophisticated functions, we suggest you read through this manual thoroughly. Also keep it in a safe place for future reference. Package Contents Two speakers, mixer, panel, power cord, two speaker cables, Owner's Manual (this booklet) NOTE: The mixer and the panel are installed in the speakers when the STAGEPAS 300 leaves the factory. Dimensions Troubleshooting Power does not turn on Is the included power cord correctly connected to a power outlet? Speaker Mixer MSC 1 2 3 160 MSC 1 455. 5 2 3 MSC 1 Before turning on the mixer Remove the mixer 1. Be sure that the mixer's power switch is turned off. Power shuts down suddenly Is the vent on the top panel of the mixer blocked? [. . . ] 16F 23-8 Yoido-dong, Youngdungpo-ku, Seoul, Kore Tel: 02-3770-0660 3. Plug the power cord into a power outlet. Outputting the signal for monitoring Connect a powered speaker to the MONITOR OUT jack. The MONITOR OUT jack outputs the signal prior to routing through the MASTER LEVEL control. Adjust the level of output signal from the MONITOR OUT jack with the MONITOR OUT control. The MONITOR OUT control does not affect the MASTER LEVEL control. If the signals are output from the L (left) MONITOR OUT jack, the mixer feeds the mixed L and R signals to the jack. SPAIN/PORTUGAL Yamaha-Hazen Música, S. A. 17, 200, 28230 Las Rozas (Madrid), Spain Tel: 91-639-8888 MALAYSIA Yamaha Music Malaysia, Sdn. , Bhd. Lot 8, Jalan Perbandaran, 47301 Kelana Jaya, Petaling Jaya, Selangor, Malaysia Tel: 3-78030900 CAUTION Always follow the basic precautions listed below to avoid the possibility of physical injury to you or others, or damage to the device or other property. These precautions include, but are not limited to, the following: BRAZIL Yamaha Musical do Brasil Ltda. Reboucas 2636-Pinheiros CEP: 05402-400 Sao Paulo-SP. Brasil Tel: 011-3085-1377 Turning the power on/ off Caution SWEDEN Yamaha Scandinavia AB J. Wettergrens Gata 1 Box 30053 S-400 43 Göteborg, Sweden Tel: 031 89 34 00 SINGAPORE Yamaha Music Asia Pte. , Ltd. #03-11 A-Z Building 140 Paya Lebor Road, Singapore 409015 Tel: 747-4374 ARGENTINA Yamaha Music Latin America, S. A. Sucursal de Argentina Viamonte 1145 Piso2-B 1053, Buenos Aires, Argentina Tel: 1-4371-7021 Power supply/Power cord · Remove the electric plug from the outlet when the device is not to be used for extended periods of time, or during electrical storms. · When removing the electric plug from the device or an outlet, always hold the plug itself and not the cord. Pulling by the cord can damage it. Handling caution · When turning on the AC power in your audio system, always turn on the device LAST, to avoid speaker damage. When turning the power off, the device should be turned off FIRST for the same reason. · Do not insert your fingers or hands in any gaps or openings on the device (vents, , ports, etc. ). · Avoid inserting or dropping foreign objects (paper, plastic, metal, etc. ) into any gaps or openings on the device (vents, ports, etc. ) If this happens, turn off the power immediately and unplug the power cord from the AC outlet. Then have the device inspected by qualified Yamaha service personnel. · Do not use the device for a long period of time at a high or uncomfortable volume level, since this can cause permanent hearing loss. If you experience any hearing loss or ringing in the ears, consult a physician. [. . . ] For low-level signals (such as that of microphones), set the MIC/LINE switch to the MIC ( ) position. For high-level signals (such as keyboard instruments and audio equipment), set the MIC/LINE switch to the LINE ( ) position. NOTE: On any given channel, you may use either XLR or phone jack, but not both. Please connect to only one of these jacks on each channel. R REC OUT L/R jacks These output the mixed signal channels from 1 to 7/8, and the level is unaffected by the MASTER LEVEL control. You can use these jacks, for example, to connect to an external recorder. Stereo channel input jacks (CH 5/6, 7/8) Input the left and right channels of a stereo signal into the respective odd and even channels of the mixer. These inputs are intended mainly for use with instruments and equipment having stereo outputs, such as a synthesizer or CD player. NOTE: The channel 5/6 input provides two sets of jacks--both phone jacks and RCA-pin jacks. [. . . ]