User manual YAMAHA TF5/TF3/TF1 QUICK GUIDE

[. . . ] To take full advantage of the superior features and performance offered by your TF-series console, and to enjoy years of trouble-free use, please read this document carefully before operating your console. 7 2-6 Nomenclature used in this document. The above warning is located on the rear of the unit. l’avertissement ci-dessus est situé sur l’arrière de l’unité. [. . . ] You can select which signal is output on the OMNI OUT screen. 2 ST IN jacks Stereo input jacks that can be used for connecting a CD player or other line level device. These jacks are unbalanced female RCA jacks. 3 INPUT jacks Combination jacks that support both XLR and TRS phone connectors. The head amp setting for each jack is saved in memory. 4 NETWORK connector RJ-45 jack used to connect the console to a computer via an Ethernet cable (CAT5e or higher recommended). This connector is used mainly to control mix parameters or to edit Scene memories and Libraries from the dedicated "TF Editor" program or the iPad app. 5 USB TO HOST connector USB connector used to connect the console to a computer, allowing the console to function as an audio interface. supports input and output for 34 channels of 48 kHz , 24-bit audio. When using with a computer running Microsoft Windows, the Yamaha Steinberg USB Driver is required. 6 FOOT SW jack Used for connecting an optional FC5 foot switch. You can use the connected foot switch as an effect bypass switch, a mute switch, or use it to tap the delay time. 7 Expansion slot An expansion slot to be used in the future. 0 AC IN connector Connect the included power cord. When connecting to a power outlet, first connect the power cord to the console, then connect the power cord to the power outlet. CAUTION • Make sure the unit is turned off before connecting or disconnecting the power cord. € Disconnect the power cord from the outlet when the unit will not be used for extended periods of time (page 8). Connections 5-1 Connecting inputs Default signal routing for each channel CHANNEL CH 1 : CH 16 CH 17 : CH 24 CH 25 : CH 32 CH 33 : CH 40 ST IN 1L ST IN 1R ST IN 2L ST IN 2R ANALOG INPUT TF5 INPUT 1 : INPUT 16 INPUT 17 : INPUT 24 INPUT 25 : INPUT 32 INPUT 1 : INPUT 8 ST IN 1L ST IN 1R ST IN 2L ST IN 2R TF3 INPUT 1 : INPUT 16 INPUT 17 : INPUT 24 INPUT 1 : INPUT 8 INPUT 9 : INPUT 16 ST IN 1L ST IN 1R ST IN 2L ST IN 2R TF1 INPUT 1 : INPUT 16 INPUT 1 : INPUT 8 INPUT 9 : INPUT 16 : ST IN 1L ST IN 1R ST IN 2L ST IN 2R Electric guitar or bass Keyboard or synthesizer Direct box Mic Default signal routing for each channel is shown above. To change the signal routing, use the INPUT screen (page 18). Some direct boxes also need phantom power. When using phantom power, first set "+48V Master" on the SYSTEM SETUP screen to on, then turn phantom power on or off for each channel on the corresponding channel's INPUT screen. Make sure you turn phantom power off if it is not needed. [. . . ] NOTE In addition to the internal clock, you can configure the following items. For details, refer to the Reference Manual. € AUX bus signal type • Network settings • OMNI OUT settings • Recall Safe channels 1 Prepare the console by removing the side pads. 1 Remove the two screws that secure each side pad. [. . . ]