User manual YAMAHA TG300E2

[. . . ] Bumping into the instrument may result in injury. It may also cause instrument may also fall over. If an earthquake occurs, strong shocks caused by the earthquake may overturn the instrument or cause it to move about. Stay away from the instrument during earthquakes. [. . . ] Always move the chimes slowly, with two persons supporting the side columns as shown in the illustration on the right. Doing so can result in the chimes running out of control and hitting an obstacle or wall causing serious injury. If the chimes must be lifted when being moved, lift them carefully, using as many persons as possible to avoid injury. At this time, lift the chimes by holding the base section and supporting the side column making sure that the hanger section (from which the sound columns hang) remains in an upright position. Never lift the base section higher than the hanger section. Doing so can result in the sound columns coming off the hanger. â· Moving the instrument up or down stairs should never be done with the instrument assembled. Doing so is a danger as parts can fall off, or you can loose balance causing the instrument to fall over. Only move the instrument after it has been disassembled. Injury or handicaps to persons caused by the disregard of warnings with this mark or, misuse of the instrument, may result in the loss of personal property. Do not use the hammer for anything other than playing the instrument. The shape of the stand may change and the column's wire/ strings may be cut if the columns are not removed. 4 When attaching or removing the sound columns, do so in a place where there is sufficient room so that the columns do not come into contact with other objects. 5 After the sound columns are removed, wrap them in a soft cloth, etc. Make sure the chimes are assembled or disassembled by at least two persons. * The following procedure is carried out to ensure that the performer faces forward when playing the instrument. Fully loosen screws A, and then slide the pedal assembly pipe all the way into the hole on the base section. After connecting the assembly pipe to the base sections, lock the casters (left and right). Insert the side columns into the holes on the left and right base sections. Fully loosen screws B and insert the end of the side column pipe with the small hole on its side, all the way into the left and right side base sections. * Both left and right side columns are the same. * To make attachment of the damper and hanger sections easier, do not tighten screws B yet. [. . . ] Firmly tighten screws B and C on both right and left sides and secure. Pull the damper pedal out to the front, and then hook the hook on the end of the pull rod onto the damper rod. At this time, pull down on the pull rod knob to hook onto the damper rod, then release the pull rod knob. * Do not press down on the damper pedal. [. . . ]