User manual YAMAHA TRP150 OX66 V MAX-2002

[. . . ] DX150A OWNER'S MANUAL U. S. A. Edition LIT-18626-04-60 E EMU01448 TO THE OWNER Thank you for choosing a Yamaha outboard motor. This Owner's manual contains information needed for proper operation, maintenance and care. A thorough understanding of these simple instructions will help you obtain maximum enjoyment from your new Yamaha. If you have any question about the operation or maintenance of your outboard motor, please consult a Yamaha dealer. [. . . ] Perform the flushing and fogging at the same time. w 8 Do not touch or remove electrical parts when starting or during operation. 8 Keep hands, hair and clothes away from flywheel and other rotating parts while engine is running. EMU00344 Flushing with the Flushing Device w Keep yourself and others away from the propeller while engine is running. q we cC Avoid running the outboard at high speed while flushing, or overheating could occur. 1) 2) 3) Remove the top cowling and silencer cover. Unscrew the garden-hose connector 2 from the bottom cowling fitting 1. Screw the garden-hose connector 2 onto a garden-hose 3 which is connected to a fresh-water supply. Open the water tap and let the water flush through the cooling passages. Run the engine at an idle speed in neutral for about 15 minutes. 4) 5) 000843 4-4 E 6) Just prior to turning off the engine, quickly spray "Yamaha Stor-Rite Engine Fogging Oil" (Part No. LUBSTRRT-12-00) alternately into each carburetor. When properly done, the engine will smoke excessively and almost stall. After stopping the engine, turn off the water and disconnect the gardenhose connector. Reinstall the garden-hose connector on the fitting on the bottom cooling. Install the silencer cover and top cowling. 7) 8) 9) cC Do not leave the garden-hose connector loose on the bottom cowling or let the hose hang free during normal operation. Water will leak out of the connector instead of cooling the engine, which can cause serious overheating. Be sure the connector is tightened securely on the fitting after flushing the engine. 4-5 E EMU00350* Lubrication 1) Remove the spark plug(s). Spray a "Yamaha Stor-Rite Engine Fogging Oil" into each cylinder for 5 seconds. Grease the spark plug threads and reinstall the spark plug(s) and torque to proper specification. (Refer to "CLEANING AND ADJUSTING SPARK PLUG". ) 2) Turn the engine over with the stop lanyard disconnected to work the fogging oil into the piston rings. This prevents the formation of condensation. For models with a remote tank, it may be necessary to manually override the control unit to completely fill the engine main tank. (Refer to "CHANGING GEAR OIL"). Inspect the oil for the presence of water which indicates a leaky seal. Seal replacement should be performed by an authorized Yamaha dealership prior to use. [. . . ] don't forget to include any important information such as names, addresses, model, engine serial number, dates, and receipts. CHANGE OF ADDRESS The federal government requires each manufacturer of a motor vehicle to maintain a complete, up-to-date list of all first purchasers against the possibility of a safety-related defect and recall. This list is complied from the purchase registrations sent to Yamaha Motor Corporation, U. S. A. by the selling dealer at the time of your purchase. [. . . ]