User manual YAMAHA TTR250-2004

[. . . ] OWNER'S MANUAL TTR250S(C) LIT-11626-17-01 5GF-28199-15 INTRODUCTION EAU10060 Congratulations on your purchase of the Yamaha TTR250. This model is the result of Yamaha's vast experience in the production of fine sporting, touring, and pacesetting racing machines. It represents the high degree of craftsmanship and reliability that have made Yamaha a leader in these fields. This manual will give you an understanding of the operation, inspection, and basic maintenance of this machine. [. . . ] A slight tilt to the side can result in a false reading. Start the engine, warm it up for several minutes, and then turn it off. Wait a few minutes until the oil settles, and then check the oil level through the check window located at the bottom-right side of the 1 2 3 4 5 6 crankcase. NOTE: The engine oil should be between the minimum and maximum level marks. 1 2 3 1. If the engine oil is below the minimum level mark, add sufficient oil of the recommended type to raise it to the correct level. To change the engine oil (with or without oil filter element cleaning) 1. Start the engine, warm it up for several minutes, and then turn it off. Place an oil pan under the engine 6-7 PERIODIC MAINTENANCE AND MINOR REPAIR to collect the used oil. Remove the engine oil filler bolt and drain bolt to drain the oil from the crankcase. Remove the oil filter element drain bolt to drain the oil from the oil filter element. 2(×3) 1 2 3 1. O-ring 3 2(×2) 1 1 4 5 6 7 8 9 1. Oil filter element cover NOTE: Skip steps 5­9 if the oil filter element is not being cleaned. Remove the oil filter element cover by removing the bolts. Remove the oil filter element and O-rings. 7. Check the O-rings for damage and replace them if necessary. Clean the oil filter element with solvent, and then install it. NOTE: Check the oil filter element for damage and replace it if necessary. 1 1. Engine oil drain bolt NOTE: Check each washer for damage and re6-8 PERIODIC MAINTENANCE AND MINOR REPAIR 9. Install the oil filter element cover by installing the bolts, then tightening them to the specified torque. 1 2 3 4 5 6 7 8 9 Tightening torque: Oil filter element cover bolt: 10 Nm (1. 0 m·kgf, 7. 2 ft·lbf) NOTE: Make sure that the O-rings are properly seated. Install the engine oil drain bolt, and then tighten it to the specified torque. Install the engine oil filter element drain bolt, and then tighten it to the specified torque. [. . . ] "AMONG THOSE ACTS PRESUMED TO CONSTITUTE TAMPERING ARE THE ACTS LISTED BELOW". These acts include tampering with the following systems; i. e. , modification, removal, etc. Exhaust system G Muffler G Exhaust pipe G Silencer Intake system G Air cleaner case G Air cleaner element G Intake duct 9-3 CONSUMER INFORMATION EAU26651 Maintenance record Have a Yamaha dealer complete this record when the machine is serviced. Maintenance interval Date of service Mileage Servicing dealer name and address Remarks 2 3 4 5 6 7 8 9 9-4 CONSUMER INFORMATION EAU26670 YAMAHA MOTOR CORPORATION, U. S. A. OFF-ROAD MOTORCYCLE LIMITED WARRANTY 1 2 3 4 5 6 7 8 9 9-5 CONSUMER INFORMATION 2 3 4 5 6 7 8 9 9-6 CONSUMER INFORMATION EAU26750 YAMAHA EXTENDED SERVICE (Y. E. S. ) Keep your Yamaha protected even after your warranty expires with genuine Yamaha Extended Service (Y. E. S. ). 1 2 3 4 5 6 7 8 9 Y. E. S. is designed and administered by Yamaha Motor Corporation to provide maximum owner satisfaction. [. . . ]