User manual YAMAHA TTR250-2006

[. . . ] OWNER'S MANUAL TTR250V(C) LIT-11626-19-30 5GF-28199-17 INTRODUCTION EAU10060 Congratulations on your purchase of the Yamaha TTR250V. This model is the result of Yamaha's vast experience in the production of fine sporting, touring, and pacesetting racing machines. It represents the high degree of craftsmanship and reliability that have made Yamaha a leader in these fields. This manual will give you an understanding of the operation, inspection, and basic maintenance of this machine. [. . . ] Remove the oil filter element and O-rings. 7. Check the O-rings for damage and replace them if necessary. Clean the oil filter element with solvent, and then install it. NOTE: Check the oil filter element for damage and replace it if necessary. Install the oil filter element cover by installing the bolts, then tightening them to the specified torque. 12. Add the specified amount of the recommended engine oil, and then install and tighten the oil filler cap. 6-10 PERIODIC MAINTENANCE AND MINOR REPAIR Recommended oil: See page 8-1. Oil quantity: Without oil filter element replacement: 1. 10 L (1. 16 US qt) (0. 97 Imp. qt) With oil filter element replacement: 1. 20 L (1. 27 US qt) (1. 06 Imp. qt) ECA11620 check the oil level and correct it if necessary. ECA10970 1 CAUTION: G In order to prevent clutch slippage (since the engine oil also lubricates the clutch), do not mix any chemical additives. Do not use oils with a diesel specification of "CD" or oils of a higher quality than specified. In addition, do not use oils labeled "ENERGY CONSERVING II" or higher. G Make sure that no foreign material enters the crankcase. Start the engine, and then let it idle for several minutes while checking it for oil leakage. If oil is leaking, immediately turn the engine off and check for the cause. Turn the engine off, and then CAUTION: After replacing the engine oil, make sure to check the oil pressure as described below. G Remove the bleed bolt from the engine oil filter element cover. G Start the engine and keep it idling until oil flows out. If no oil comes out after one minute, turn the engine off immediately so it will not seize. If this occurs, have a Yamaha dealer repair the vehicle. G After checking the oil pressure, tighten the bleed bolt to the specified torque. 2 3 1. Bleed bolt Tightening torque: Bleed bolt: 7 Nm (0. 7 m·kgf, 5. 0 ft·lbf) 4 5 6 7 8 9 6-11 PERIODIC MAINTENANCE AND MINOR REPAIR EAU20890 Cleaning the air filter element 1 2 3 4 5 6 7 8 9 1. Holding clip 1 1 2 The air filter element should be cleaned at the intervals specified in the periodic maintenance and lubrication chart. Clean the air filter element more frequently if you are riding in unusually wet or dusty areas. Remove the air filter case cover by removing the holding clips. 3 4 1. [. . . ] 1-5 Light switch. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-2 C Cables, checking and lubricating . . . . . . . . . . . . . 6-23 Carburetor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-14 Care . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-1 Cleaning the spark arrester . . . . . . . . . . . . . . . . . . . . . 6-13 Clutch lever. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-2 Clutch lever free play, adjusting . . . . . . . . . . . . . . 6-18 Cowling and panels, removing and installing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-6 M Main switch. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-1 Maintenance and lubrication, periodic. . . . . . . 6-3 Maintenance, emission control system . . . . . [. . . ]