User manual YAMAHA TYROS 2 VOICE EDITOR

[. . . ] Tyros2 Voice Editor Owner's Manual Contents About the Voice Editor . 4 Tyros2 Voice Editor Voice Editor Procedure . 22 · The software and this owner's manual are exclusive copyrights of Yamaha Corporation. · Copying of the software or reproduction of this manual in whole or in part by any means is expressly forbidden without the written consent of the manufacturer. [. . . ] Detailed parameter settings can be checked in the EL Detail dialog window by clicking the DETAIL button. Element Selection Opens the EL Detail (Element Detail) dialog window for detailed numeric editing and verification. OSCILLATOR Selects the elements that make up a voice (category, voice number, element number), and provides access to the VEL LIMIT and NOTE LIMIT parameters. One of the markers sets the VEL LIMIT LOW and NOTE LIMIT LOW parameters. Dragging the marker to the left or right sets the lowest note in the element's keyboard range, and dragging the marker up or down sets the lowest keyboard velocity at which the element will sound. The other marker is used to adjust the VEL LIMIT HIGH and NOTE LIMIT HIGH parameters. Dragging this marker to the left or right sets the highest note in the element's keyboard range, and dragging the marker up or down sets the highest keyboard velocity at which the element will sound. The active range is displayed in green on the graph. NOTE The following parameters can be set via the OSCILLATOR page of the EL Detail dialog window. Category, Voice, Element Volume Pan Key On Delay Time Pitch Scaling Center Note Selects or deletes the elements that make up the voice. Adjusts the pan (stereo position) of the element. Sets a delay between key-on and the instant the element begins to produce sound. Different delays can be set for each element. Sets the center note for keyboard pitch scaling (keyboard: note number). The pitch of the specified center note will not change regardless of the pitch scaling sensitivity setting. Sets the pitch scaling sensitivity of the element (the amount of pitch variation between adjacent notes). Sets the volume response curve in relation to keyboard dynamics. Three curves are provided: Medium, Soft and Hard. Adjusts the keyboard dynamics sensitivity based on the Touch Curve setting above. Adjusts the pitch of the element in semitone steps. Allows fine adjustment of element pitch. Set the keyboard range over which the element will sound. Set the velocity range over which the element will sound. Pitch Scaling Sens. Note Shift Tune Fine Note Limit High, Note Limit Low Velocity Limit High, Velocity Limit Low NOTE Regardless of the Note Limit or Velocity Limit parameter settings, some Elements do not sound for specific notes/velocities. 15 Tyros2 Voice Editor FILTER 1 Sets the FILTER 1 parameters. Drag the marker to the left or right to adjust the filter's cutoff frequency, and therefore the brightness of the sound. Drag the marker upward to increase the filter's resonance -- a resonant peak at the cutoff frequency -- to produce resonant analog synthesizer type timbres. NOTE · These parameters can also be edited numerically via the EL Detail dialog window DCF page. [. . . ] Editing via the graph is the same as in the element dialogs. This parameter is linked to !0 and !1, above. @1 Amplitude EG Adjusts the amplitude envelope of the sound from initial attack through final decay. This parameter is linked to !2, !3, and !4, above. Toolbar q w e r q Editor Setup Button Opens the Setup dialog window. Refer to page 10 for details on the Setup dialog window. w Library Window Button Opens the Library Window. [. . . ]