User manual YAMAHA UW500E

[. . . ] USB AUDIO/MIDI PERSONAL STUDIO USB AUDIO/MIDI PERSONAL STUDIO Owner`s Manual Bedienungsanleitung Mode d'emploi Français Deutsch English SPECIAL MESSAGE SECTION This product utilizes batteries or an external power supply (adapter). DO NOT connect this product to any power supply or adapter other than one described in the manual, on the name plate, or specifically recommended by Yamaha. Battery Notice: This product MAY contain a small non-rechargeable battery which (if applicable) is soldered in place. The average life span of this type of battery is approximately five years. When replacement becomes necessary, contact a qualified service representative to perform the replacement. [. . . ] USB-MIDI driver is software that transmits MIDI signals back and forth between sequence software and the UW500 via a USB cable. The USB audio driver is software that transmits and receives audio signals via a USB cable. computer USB audio driver USB cable USB-MIDI driver MIDI data UW500 sequence software audio data 22 Installing the Driver · Installation Follow the steps below to install three drivers (USB Composite Device, USB-MIDI Driver, and USB Audio Device). NOTE If you are using a USB device that has one or two of these drivers already installed, part of installation process may be automatically omitted. Make sure that the power to the UW500 is turned off (standby). Connect the USB terminal of the computer or the USB hub to the USB terminal of the UW500 using the included USB cable. The system displays the "Add New Hardware Wizard. " 3. 23 Installing the Driver 4. The system displays a screen that enables you to select search method. 5. Check the radio button to the left of "Search for the best driver for your device. The system displays a screen that enables you to select a location in which to install the driver. 6. Insert the included CD-ROM into the CD-ROM drive. After making sure that the system recognizes the CD-ROM, check the "Specify a location" box and uncheck all other items. Click [Browse] and specify the "USBdrv_" folder on the CD-ROM drive (such as D:\USBdrv_). Click [Next]. 24 Installing the Driver 7. When the system detects the driver and is ready for installation, it displays the following screen. Make sure that the "USB Composite Device" is listed, and click [Next]. The system starts installation. NOTE The installation dialog may prompt you to insert the Windows 98 CD-ROM. In this case, insert the Windows 98 CD-ROM into the CD-ROM drive, specify an appropriate directory for the CD-ROM drive (such as "D:\Win98"), then continue the installation. The drive name and directory will vary depending on the computer. 8. When installation is complete, the following screen appears. Click [Finish]. NOTE Some computers may take about ten seconds to show this screen after installation is complete. 25 Installing the Driver 9. "Add New Hardware Wizard" appears again in a while. Install "YAMAHA USB MIDI Driver" in the same manner as steps 3-8 described above. NOTE NOTE The first screen indicates "YAMAHA UW500" or "Unknown device" as shown below. The system may ask you to insert a Windows98 CD-ROM while it checks for the driver. Specify the "USBdrv_" folder of the included CD-ROM (such as D:\USBdrv_) and continue installation. 10. "Add New Hardware Wizard" appears again in a while. Install "USB Audio Device" in the same manner as steps 3-8 described above. 26 Installing the Driver 11. [. . . ] Do not select unnecessary devices here. 53 SOFTWARE LICENSING AGREEMENT The following is a legal agreement between you, the end user, and Yamaha Corporation ("Yamaha"). The enclosed Yamaha software program is licensed by Yamaha to the original purchaser for use only on the terms set forth herein. Please read this licensing agreement with care. Opening this package indicates that you accept all terms outlined herein. [. . . ]