User manual YAMAHA V STAR CLASSIC-2003

[. . . ] OWNER'S MANUAL XVS650R(C) XVS650AR(C) LIT-11626-16-05 5FB-28199-12 EAU03438 EAU00002 INTRODUCTION Congratulations on your purchase of the Yamaha XVS650(C)/XVS650A(C). This model is the result of Yamaha's vast experience in the production of fine sporting, touring, and pacesetting racing machines. It represents the high degree of craftsmanship and reliability that have made Yamaha a leader in these fields. This manual will give you an understanding of the operation, inspection, and basic maintenance of this motorcycle. [. . . ] Spark plug wrench EAU03329 To install the panel Place the panel in the original position, and then install the screw. 6 Checking the spark plugs The spark plugs are important engine components, which are easy to check. Since heat and deposits will cause any spark plug to slowly erode, the spark plugs should be removed and checked in accordance with the periodic maintenance and lubrication chart. In addition, the condition of the spark plugs can reveal the condition of the engine. Remove the spark plug as shown, with the spark plug wrench included in the owner's tool kit. Check that the porcelain insulator around the center electrode on each spark plug is a medium-tolight tan (the ideal color when the motorcycle is ridden normally). Check that all spark plugs installed in the engine have the same color. 6-9 PERIODIC MAINTENANCE AND MINOR REPAIR NOTE: If any spark plug shows a distinctly different color, the engine could be defective. Do not attempt to diagnose such problems yourself. Instead, have a Yamaha dealer check the motorcycle. @ @ Tightening torque: Spark plug: 18 Nm (1. 8 m·kgf, 13 ft·lbf) NOTE: If a torque wrench is not available when installing a spark plug, a good estimate of the correct torque is 1/4­1/2 turn past finger tight. However, the spark plug should be tightened to the specified torque as soon as possible. @ @ 3. Check each spark plug for electrode erosion and excessive carbon or other deposits, and replace it if necessary. Specified spark plug: DPR7EA-9 (NGK) or X22EPR-U9 (DENSO) a. Spark plug gap To install a spark plug 1. Measure the spark plug gap with a wire thickness gauge and, if necessary, adjust the gap to specification. Spark plug gap: 0. 8­0. 9 mm (0. 03­0. 04 in) 2. Clean the surface of the spark plug gasket and its mating surface, and then wipe off any grime from the spark plug threads. Install the spark plug with the spark plug wrench, and then tighten it to the specified torque. 6-10 4. 6 PERIODIC MAINTENANCE AND MINOR REPAIR EAU04612 Engine oil and oil filter element The engine oil level should be checked before each ride. In addition, the oil must be changed and the oil filter element replaced at the intervals specified in the periodic maintenance and lubrication chart. Place the motorcycle on a level surface and hold it in an upright position. 4. Engine oil level check window Maximum level mark Minimum level mark Engine oil filler cap Canister (for California only) This model is equipped with a canister to prevent the discharging of fuel vapor into the atmosphere. G Check each hose and canister for cracks or damage. [. . . ] 7-4 Storage compartment . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-13 Supporting the motorcycle . . . . . . . . . . . . . . . . . . . . . 6-36 V Valve clearance, adjusting . . . . . . . . . . . . . . . . . . . . 6-17 Vehicle identification number. . . . . . . . . . . . . . . . . . . [. . . ]