User manual YAMAHA V-MAX-2003

[. . . ] OWNER'S MANUAL VMX12R VMX12RC LIT-11626-16-20 5GK-28199-13 EAU03438 EAU00002 INTRODUCTION Congratulations on your purchase of the Yamaha VMX12/VMX12C. This model is the result of Yamaha's vast experience in the production of fine sporting, touring, and pacesetting racing machines. It represents the high degree of craftsmanship and reliability that have made Yamaha a leader in these fields. This manual will give you an understanding of the operation, inspection, and basic maintenance of this motorcycle. [. . . ] In addition, the oil must be changed and the oil filter cartridge replaced at the intervals specified in the periodic maintenance and lubrication chart. Place the motorcycle on the centerstand. NOTE: Make sure that the motorcycle is positioned straight up when checking the oil level. A slight tilt to the side can result in a false reading. _ _ 4. 6 EAU01796 Canister (for California only) This model is equipped with a canister to prevent the discharging of fuel vapor into the atmosphere. G Check each hose and canister for cracks or damage. G Make sure the vent hose is not blocked. Start the engine, warm it up for several minutes, and then turn it off. 6-11 PERIODIC MAINTENANCE AND MINOR REPAIR 1. Wait a few minutes until the oil settles, and then check the oil level through the check window located at the bottom-right side of the crankcase. NOTE: The engine oil should be between the minimum and maximum level marks. _ _ To change the engine oil (with or without oil filter cartridge replacement) 1. Start the engine, warm it up for several minutes, and then turn it off. Place an oil pan under the engine to collect the used oil. 3. Remove the engine oil filler cap and drain bolt to drain the oil from the crankcase. NOTE: Skip steps 4­6 if the oil filter cartridge is not being replaced. _ _ 6 4. If the engine oil is below the minimum level mark, add sufficient oil of the recommended type to raise it to the correct level. 6-12 PERIODIC MAINTENANCE AND MINOR REPAIR 1. Remove the oil filter cartridge with an oil filter wrench. 6 NOTE: An oil filter wrench is available at a Yamaha dealer. _ _ _ _ 5. Apply a thin coat of engine oil to the O-ring of the new oil filter cartridge. NOTE: Make sure that the O-ring is properly seated. 6. Install the new oil filter cartridge with an oil filter wrench, and then tighten it to the specified torque with a torque wrench. Tightening torque: Oil filter cartridge: 17 Nm (1. 7 m·kgf, 12 ft·lbf) 7. Install the engine oil drain bolt, and then tighten it to the specified torque. [. . . ] 3-15 Wheel bearings, checking . . . . . . . . . . . . . . . . . . . . . 6-35 Wheel (front) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-42 Installing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-42 Removing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]