User manual YAMAHA VENTURE 700-2004

[. . . ] SNOWMOBILE OWNER'S MANUAL SXV70ERJ SXV70MJ SXV70SJ VT70J LIT-12628-02-31 8EK-28199-12 A ESU00286 1- MACHINE IDENTIFICATION Identification number records A. ENGINE NUMBER (PRIMARY ID): CZ-01E C. KEY NUMBER: C CZ-01E Record the frame number, engine number (Primary ID), and key number in the spaces provided for assistance when ordering spare parts from a Yamaha dealer. 1 The frame number is the seventeen-digit number stamped on the frame of the snowmobile. [. . . ] To minimize possible damage, consult your stud manufacturer for installation and stud pattern recommendations. Yamaha does not recommend track studding. 7-9 ESU00245 Strap For SXV70M The strap 1 should be used only by experienced operators to assist them when traverse (side-hill) riding. WARNING @ Improper use of the strap on the handlebar can result in severe injury or death. G Use the strap only as an operator grip point when needed to shift weight uphill to maintain balance during traverse (side-hill) riding. Only experienced operators should traverse slopes steep enough to require strap use. G Keep the right hand on the right handlebar grip for steering, and grip the strap with the left hand to shift weight uphill for balance during traverse riding. G Ride cautiously while using the strap. Do not accelerate or decelerate abruptly while holding onto the strap. G Do not use the strap to lift the snowmobile. G Do not use the strap as a mounting point for cargo or accessories. @ 7-10 ESU00318 Driving WARNING @ Be sure to read the "SAFETY INFORMATION" and "Riding your snowmobile" sections carefully before operating the snowmobile. @ NOTE: @ Make sure that the engine is warmed up enough before riding. @ For SXV70M/SXV70S 1. Release the parking brake by moving the parking brake lever to the right. Press the throttle lever slowly to move the snowmobile. Turn the handlebar in the desired direction. Squeeze the brake lever to stop the snowmobile. Apply the parking brake by moving the parking brake lever to the left. Select the desirable operating position by moving the shift lever. 1 Push down 2 "FWD" Forward 3 "REV" Reverse WARNING @ G G G G @ Make sure that the throttle lever is fully released and the snowmobile is at a full stop before shifting. Be sure to move the shift lever to forward or reverse until it stops completely while the engine is idling. Make sure that the area behind the snowmobile is clear before reversing. Reduce speed and avoid sharp turning when operating the snowmobile in reverse. NOTE: @ The reverse buzzer beeps while the shift lever is in reverse. @ 7-11 2. Release the parking brake by moving the parking brake lever to the right. Press the throttle lever slowly to move the snowmobile. Turn the handlebar in the desired direction. [. . . ] Apply suitable protectants to the exterior of the engine, drive track, and to other metal, plastic, and rubber parts. Battery For SXV70ER/VT70 Remove the battery from the snowmobile and check the fluid level. (See the "Battery-- Replenishing the battery fluid" section on page 8-31 for instructions. ) After checking the fluid level, charge the battery. Store it in a cool, dry place that is above 0 °C (32 °F), but less than 30 °C (90 °F). [. . . ]