User manual YAMAHA VIRAGO XV250VC

[. . . ] OWNER'S MANUAL XV250V XV250VC LIT-11626-19-23 2UJ-28199-1E EAU10041 INTRODUCTION EAU10080 Congratulations on your purchase of the Yamaha XV250V/XV250VC. This model is the result of Yamaha's vast experience in the production of fine sporting, touring, and pacesetting racing machines. It represents the high degree of craftsmanship and reliability that have made Yamaha a leader in these fields. This manual will give you an understanding of the operation, inspection, and basic maintenance of this motorcycle. [. . . ] Install the oil filter element cover by installing the bolts, then tightening them to the specified torque. 6 Tightening torque: Oil filter element cover bolt: 7. 0 Nm (0. 7 m·kgf, 5. 1 ft·lbf) CAUTION: G NOTE: Make sure that the O-ring is properly seated. Install the engine oil drain bolt, and then tighten it to the specified torque. In order to prevent clutch slippage (since the engine oil also lubricates the clutch), do not mix any chemical additives. Do not use oils with a diesel specification of "CD" or oils of a higher quality than specified. In addition, do not use oils labeled "ENERGY CONSERVING II" or higher. 6-12 PERIODIC MAINTENANCE AND MINOR REPAIR EAU32732 Cleaning the air filter element The air filter element should be cleaned at the intervals specified in the periodic maintenance and lubrication chart. Clean the air filter element more frequently if you are riding in unusually wet or dusty areas. Remove the bolts and loosen the air filter case joint clamp screw. 3. Remove the air filter case cover by removing the screws. 1. Disconnect the hoses from the air filter case, and then remove the air filter case. 4. Remove the air filter element by removing the wing nut. Air filter element 6-13 PERIODIC MAINTENANCE AND MINOR REPAIR 5. Remove the sponge material from the air filter element frame, clean it with solvent, and then squeeze the remaining solvent out. Pull the sponge material over the air filter element frame. Insert the element into the air filter case, and then tighten the wing nut. ECA10480 EAU21251 Carburetor The carburetor is an important part of the engine and its emission control system, which requires very sophisticated adjustment. Therefore, carburetor adjustments should be left to Yamaha dealer, who has the necessary professional knowledge and experience. CAUTION: G G 6 1. Air filter element frame Make sure that the air filter element is properly seated in the air filter case. The engine should never be operated without the air filter element installed, otherwise the piston(s) and/or cylinder(s) may become excessively worn. 6. Apply oil of the recommended type to the entire surface of the sponge material, and then squeeze the excess oil out. NOTE: The air filter element should be wet but not dripping. Recommended oil: Yamaha foam air filter oil or other quality air filter oil 9. Install the air filter case cover by installing the screws. Connect the hoses to the air filter case. Push the air filter case onto the air filter case joint, and then tighten the clamp screw. [. . . ] 6-23 T Tail/brake light bulb, replacing . . . . . . . . . . . . . . 6-33 Throttle cable free play, checking . . . . . . . . . 6-15 Throttle grip and cable, checking and lubricating . . . . . . . . . . . . . . . . . . . . . 6-26 Tires . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-15 Tool kit. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-1 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]