User manual YAMAHA VK 540 LLL-2002

[. . . ] SNOWMOBILE OWNER'S MANUAL VK540EG LIT-12628-02-19 8AC-28199-18 ESU00286 A MACHINE IDENTIFICATION Identification numbers record A. KEY NUMBER: 861-011 C Record your frame number, engine number (Primary I. D. ) and key number in the spaces provided, to assist you in ordering spare parts from your Yamaha dealer. 860-002 1 The frame number is the seventeen-digit number stamped on the frame of the machine. Å) 2 The engine number is stamped in the location as shown. Ç) Also, record and keep these I. D. [. . . ] Warm up the engine until it does not run roughly or begin to stall when the starter lever is returned to the "Close" position. 815-006 ESU00125 BREAK-IN There is never a more important period in the life of your machine than the Break-In period. For the first 10 hours, approximately 200 km (125 mi), do not put an excessive load on the engine. Avoid prolonged full throttle operation. Also avoid lugging the engine, such as laborious operation in wet snow. If any abnormal condition is noticed, such as excessive vibration or noise, consult a Yamaha dealer. 7-2 ESU00273 RIDING YOUR SNOWMOBILE GETTING TO KNOW YOUR SNOWMOBILE A snowmobile is a rider active vehicle, and your riding position and your balance are the two basic factors of maneuvering your snowmobile. Riding your snowmobile requires skills acquired through practice over a period of time. Take the time to learn the basic techniques well before attempting more difficult maneuvers. Riding your new snowmobile can be a very enjoyable activity, providing you with hours of pleasure. But it is essential to familiarize yourself with the operation of the snowmobile to achieve the skill necessary to enjoy riding safely. Before you begin to ride, be sure you have read this Owner's Manual completely and understand the operation of the controls. Pay particular attention to the safety information on page 3-1 ~ 3-3. Please read all warning and caution labels on your snowmobile. Also read the Snowmobiler's Safety Handbook originally supplied with your machine. LEARNING TO RIDE YOUR SNOWMOBILE Before you ride, always perform the pre-operation checks listed on page 8-1 ~ 8-3. The short time spent checking the condition of the machine will be rewarded with added safety and a more reliable snowmobile. Always wear the proper clothing for both warmth and to help protect you from injury if an accident occurs. Become familiar with this snowmobile at slow speeds, even if you are an experienced operator. Do not attempt to operate at maximum performance until you are totally familiar with the machine's handling and performance characteristics. The beginning operator should select a large, flat area to become familiar with the snowmobile. Make sure that this area is free of obstacles and other traffic. You should practice control of the throttle and brake, and master turning techniques in this area before trying more difficult terrain. 7-3 Set the parking brake and follow the instructions on page 7-1 to start the engine. Once it has warmed up, you are ready to begin riding your Snowmobile. [. . . ] This is more important than ever in those areas where oxygenated fuel ("gasohol") is used, because the alcohol content in the fuel increases the chance for water to enter the engine. Use Yamaha Stor-Rite Fogging Oil, or an equivalent, to protect both combustion chamber and crank- shaft from corrosion. An alternate method is to remove the airbox and squirt oil into the carburetor throats while the engine is running. CAUTION: Do not attempt to store the machine by simply starting the engine occasionally during the storage period. Moisture and acids form during combustion which can actually increase the chance for corrosion damage during the storage period. [. . . ]