User manual YAMAHA VSS-200

[. . . ] This technology was developed by an engineering group led by Mr. Kunimoto, an engineer who developed the first physical modeling synthesizers, VL1 and VP1. Equalizer601 utilizes VCM technology. Special Notices · Copying of the commercially available music sequence data and/or digital audio files is strictly prohibited except for your personal use. [. . . ] · The software and this Owner's Manual are exclusive copyrights of Yamaha Corporation. · Copying of the software or reproduction of this manual in whole or in part by any means is expressly forbidden without the written consent of the manufacturer. · Yamaha makes no representations or warranties with regard to the use of the software and documentation and cannot be held responsible for the results of the use of this manual and the software. · The screen displays as illustrated in this Owner's Manual are for instructional purposes, and may appear somewhat different from the screens which appear on your computer. · The company names and product names in this Owner's Manual are the trademarks or registered trademarks of their respective companies. © 2003 Yamaha Corporation. All rights reserved. 1 Installing Equalizer601 See the Add-On Effects Installation Guide for more information on installing Equalizer601. Installing Equalizer601 As with other effects, you can recall and edit the Equalizer601 program on the console or in Studio Manager. The basic operation is as follows: 1 2 3 4 5 6 Select one of the internal effects processors. 6 7 8 9 2 filters (MID1-4). 3 n Equalizer601 is a 6-band equalizer. It consists of two shelving-type filters (LO and HI) and four peaking-type 5 [Q]/[TYPE] Studio Manager Console These parameters enable you to control the shape of the frequency response curve for each band filter. You can also set the sharpness (Q) of the frequency response curve for the MID1-4 filters. You can select the filter type for the LO band and HI band individually, choosing from four options. n The options are as follows: LSH-1, LSH-2, HPF-1, and HPF-2 for LO; 0. 50 through 16. 00 for MID1-4; LPF-1, LPF-2, HSH-1, and HSH-2 for HI. 6 [F] Frequency Studio Manager Console Specifies the filter center frequency. n The value range varies depending on the sampling frequency (fs) as follows: n If the HI filter type is set to HSH-1 ( 16. 0 Hz through 20. 0 kHz (fs=44. 1/48 kHz), or 16. 0 Hz through 40. 0 kHz (fs=88. 2/96 kHz). ) or HSH-2 ( ), the range for the HI band is 1. 0 kHz through 40. 0 kHz. 7 [G] (Gain) Studio Manager Console Specifies the filter gain. n The range is from ­18. 0 dB through +18. 0 dB. 8 [SW] button/[SW] control Studio Manager Console Turns the corresponding filter on or off. The band filter that is turned off will be disabled. 5 4 !6 9 [­]/[+] buttons Studio Manager 7 Zoom in or out the vertical axis of the graph. ) Frequency Response Curve Studio Manager Console Studio Manager displays the frequency response curves for all bands and for each band. [. . . ] The band filter that is turned off will be disabled. 5 4 !6 9 [­]/[+] buttons Studio Manager 7 Zoom in or out the vertical axis of the graph. ) Frequency Response Curve Studio Manager Console Studio Manager displays the frequency response curves for all bands and for each band. You can change the filter frequency or gain by dragging the line in the graph. [. . . ]