User manual YAMAHA XP100T

[. . . ] · Please be careful when children are close to or touching the product. Careless movement around the product may result in injury. · When setting the pads, please pay close attention to the handling and setting of cables. [. . . ] Information on disposal in other countries outside the European Union: This symbol is only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. 3 Pad-to-Input Matching Chart The function of the XP series pads varies according to which trigger input jack on the Drum Trigger Module the pad is connected. The chart below describes its function in relation to trigger input jacks. DTX900 Trigger Input Jack 1-5 Pad Rim Pad Control Functions 6-8, 12-15 ­ 9 ­ 10/11 ­ ­ : Compatible ­ : Not compatible · When using the XP series pad as a snare pad, set the pad type of the DTX900 to "XP120/100 (for snare). " When using the XP series pad as a tom pad, set the pad type of the DTX900 to "XP120/100 (for tom). " For details, refer to the Owner's Manual that came with your drum trigger module. · When connecting the XP series pad to the drum trigger module, make sure a stereo phone cable is used. If a mono phone cable (plug has one black ring) is used, the voices assigned to the A/B rim switch will not be produced. Since the XP series pad does not incorporate a switch, use of a mono phone cable is allowed. · When connecting the XP series pad to the drum trigger module, always use the supplied stereo phone cable (parallel type). Voices assigned to the A/B rim switches or pad control functions cannot be used when using a mono phone cable. Also, using any stereo phone cable other than the supplied parallel type cable may result in improper function of the pad control functions. When connecting the XP series pad to other than the drum trigger module shown in this manual, refer to the following website. http://www. yamaha. co. jp/english/product/drums/ed/ 4 Setting Up XP100T/100SD/120T After setting up your rack system (Yamaha RS series, etc. ) or a standard tom stand (Yamaha WS series, etc. ), attach the pad as shown in the illustration. Insert the tom holder (hexagonal bar) q on your rack or tom stand into the pad, and firmly tighten the clamp bolt w to secure. XP100SD/120SD Before set up, please prepare a snare stand e (Yamaha SS652, etc. ), and set the XP100SD/120SD onto the stand as you would an acoustic snare drum. CAUTION · Make sure that the pad is securely attached to the rack or stand. If the bolt is not tightened securely, the pad may slip or fall down, causing injury. Also, if the rack or stand is placed on an unstable surface, etc. , the rack or stand may fall over, resulting in injury. Connections Use the supplied stereo phone cable to connect the output jack on the XP series pad to the input jack on the DTX Series drum Trigger Module. Insert the L-shaped connector into the output jack (OUTPUT) on the XP series pad. OUTPUT 5 Pad Control Functions The pad controller used with the drum trigger module is compatible with pad control functions. [. . . ] Rua Joaquim Floriano, 913 - 4' andar, Itaim Bibi, CEP 04534-013 Sao Paulo, SP. BRAZIL Tel: 011-3704-1377 Yamaha Music Latin America, S. A. Sucursal de Argentina Olga Cossettini 1553, Piso 4 Norte Madero Este-C1107CEK Buenos Aires, Argentina Tel: 011-4119-7000 GREECE SWEDEN KOREA BRAZIL DENMARK MALAYSIA ARGENTINA FINLAND PHILIPPINES PANAMA AND OTHER LATIN AMERICAN COUNTRIES/ CARIBBEAN COUNTRIES NORWAY SINGAPORE Yamaha Music Latin America, S. A. [. . . ]