User manual YAMAHA XV1600A-2000

[. . . ] XV1600A OWNER'S MANUAL EAU00001 INTRODUCTION Welcome to the Yamaha world of motorcycling!As the owner of a Yamaha Wild StarTM, you are benefiting from Yamaha's vast experience in and newest technology for the design and the manufacture of high-quality products, which have earned Yamaha a reputation for dependability. Please take the time to read this manual thoroughly, so as to enjoy all your Yamaha Wild Star's advantages. The owner's manual does not only instruct you in how to operate, inspect and maintain your motorcycle, but also in how to safeguard yourself and others from trouble and injury. [. . . ] Tightening torque: Oil filter: 17 Nm (1. 7 m·kg) 8. Pour only 2. 5 L of oil into the oil filler hole, then install the oil filler cap and tighten it. Start the engine and rev it several times. Stop the engine and remove the oil filler cap. 6 @ CAUTION: q Do not put in any chemical additives. Engine oil also lubricates the clutch and additives could cause clutch slippage. q Be sure no foreign material enters the crankcase. @ 12. Install the oil filler cap. 6-9 PERIODIC MAINTENANCE AND MINOR REPAIR 13. Start the engine and warm it up for several minutes. While warming up, check for oil leakage. If oil leakage is found, stop the engine immediately and check for the cause. Stop the engine and recheck the oil level. 1. Transfer oil level check bolt EAU01828 1. Transfer oil drain bolt Transfer case oil Oil level inspection 1. Remove the transfer case oil check bolt. If the oil does not reach to the brim of the check hole, remove the oil filler cap and add sufficient oil through the oil filler hole. NOTE: q Install the oil level check bolt before adding oil. q Install the oil filler cap after adding oil. @ @ Oil replacement 1. Place the motorcycle on a level surface. Place an oil pan under the transfer case. Remove the transfer case oil drain and check bolts and drain the oil. Install the drain bolt and the check bolt and tighten them to the specified torques. Tightening torque: Drain bolt: 17. 5 Nm (1. 75 m·kg) Check bolt: 7. 5 Nm (0. 75 m·kg) 6 6-10 PERIODIC MAINTENANCE AND MINOR REPAIR 1. [. . . ] 6-6 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-1 Speedometer. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-3 Starter (choke) knob . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-12 Starting a warm engine. . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]