User manual YAMAHA XVS1100-2000

[. . . ] OWNER'S MANUAL XVS1100 5EL-28199-E1 EAU00001 INTRODUCTION Welcome to the Yamaha world of motorcycling!As the owner of a XVS1100, you are benefiting from Yamaha's vast experience in and newest technology for the design and the manufacture of high-quality products, which have earned Yamaha a reputation for dependability. Please take the time to read this manual thoroughly, so as to enjoy all your XVS 1100's advantages. The owner's manual does not only instruct you in how to operate, inspect and maintain your motorcycle, but also in how to safeguard yourself and others from trouble and injury. [. . . ] Oil quantity: Total amount: 3. 6 L Periodic oil change: 3. 0 L With oil filter replacement: 3. 1 L EC000066 1. With the engine stopped, check the oil level through the level window located at the lower part of the left side crankcase cover. NOTE: Wait a few minutes until the oil level settles before checking. @ @ 3. The oil level should be between the maximum and minimum marks. If the level is low, fill the engine with sufficient oil to the specified level. Engine oil replacement 1. Place an oil pan under the engine and remove the oil filler cap. Remove the drain bolt and drain the oil. Reinstall the drain bolt and tighten it to the specified torque. Tightening torque: Drain bolt: 43 Nm (4. 3 m·kg) 6 @ CAUTION: q Do not put in any chemical additives. Engine oil also lubricates the clutch and additives could cause clutch slippage. q Be sure no foreign material enters the crankcase. @ 6-8 PERIODIC MAINTENANCE AND MINOR REPAIR 6. Start the engine and warm it up for a few minutes. While warming up, check for oil leakage. If oil leakage is found, stop the engine immediately and check for the cause. NOTE: After the engine is started, the oil level indicator light should go off if oil is filled to the specified level. @ @ EC000067 1. Proper level EAU02943 6 CAUTION: If the indicator light flickers or remains on, immediately stop the engine and consult with a Yamaha dealer. @ @ Final gear oil EW000066 2. Remove the oil filler bolt and check the oil level. The oil level should be at the brim of the filler hole. Place an oil pan under the final gear case. Remove the oil filler bolt and drain bolt to drain the oil. Install and tighten the drain bolt to the specified torque. Tightening torque: Drain bolt: 23 Nm (2. 3 m·kg) 4. [. . . ] 3-10 Shifting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-5 Shift pedal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-6 Sidestand . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-15 Sidestand/clutch switch operation check . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]