User manual YAMAHA YAS-70

[. . . ] U (YAS-70CU + YAS-70SPX) CENTER SYSTEM + SUBWOOFER/SYSTEM CONTROL YAS-70 OWNER'S MANUAL IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. 1 2 3 4 5 6 7 8 9 · Explanation of Graphical Symbols The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert you to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert you to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. 10 11 12 Note to CATV system installer: This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. 13 14 Read these instructions. Install in accordance with the manufacturer's instructions. [. . . ] Doing so may cause the center system to fall. · Use commercially available screws that can endure weight enough. · Make sure you use specified screws to attach the center system to a wall. Using clamps other than specified screws, such as short screws, nails, or two-sided tape, may cause the center system to fall. · When connecting the center system, fix the speaker cables in place so that cables do not loosen. If your foot or hand accidentally gets caught on a loose speaker cable, the center system may fall. · After attaching the center system, check that the center system is fixed securely. Yamaha will bear no responsibility for any accidents caused by improper installations. 8 En Connection · Do not connect the power cable until all connections are completed. · Do not use excessive force when inserting the cable plug. Doing so may damage the cable plug and/or terminal. Connecting the center system and the subwoofer/system control PREPARATION Follow the procedure below to connect the center system and the subwoofer/system control. Connecting speaker cables Connect the cable plug to the speaker jack of the same color. Connect the cable plug to the speaker jack of the same color. FM 75 UNBAL SYSTEM CONNECTOR ANTENNA 3 1 2 L R ANALOG OPTICAL COAXIAL DOCK INPUT R L SPEAKERS Speaker cables (supplied) Connecting system control cable System control cable (supplied) FM 75 UNBAL SYSTEM CONNECTOR ANTENNA 3 1 2 L R ANALOG OPTICAL COAXIAL DOCK INPUT R L SPEAKERS Tighten the screws. Tighten the screws. English 9 En Connection Connecting external components The subwoofer/system control has 3 digital/analog input jacks (optical digital x 1, coaxial digital x 1, analog x 1). Before connecting your external components, check the output jacks of the components and be sure to use correct connection cables. Digital connection Notes · The digital jacks of this system support PCM, Dolby Digital, and DTS signal system. · The digital jacks support digital signals of which sampling frequency is 96 kHz or less. [INPUT 1] OPTICAL jack Example 1: DVD player FM 75 UNBAL SYSTEM CONNECTOR TV DVD player 3 1 ANTENNA 2 L DIGITAL OUT (OPTICAL) Optical digital cable R ANALOG OPTICAL COAXIAL DOCK INPUT R L SPEAKERS Example 2: TV game console Game console FM 75 UNBAL SYSTEM CONNECTOR TV OPTICAL DIGITAL OUTPUT ANTENNA 3 1 2 L Optical digital cable R ANALOG OPTICAL COAXIAL DOCK INPUT R L SPEAKERS [INPUT 2] COAXIAL jack FM 75 UNBAL SYSTEM CONNECTOR CD player 3 1 ANTENNA 2 L COAXIAL DIGITAL OUTPUT Coaxial digital cable R ANALOG OPTICAL COAXIAL DOCK INPUT R L SPEAKERS 10 En Connection Analog connection [INPUT 3] ANALOG jacks Example1: TV FM 75 UNBAL SYSTEM CONNECTOR ANTENNA PREPARATION L R DOCK 3 1 2 L R TV OPTICAL COAXIAL ANALOG INPUT R L AUDIO OUTPUT SPEAKERS Example 2: VCR or video camera VCR or video camera, etc. with no digital output. VCR etc. AUDIO OUTPUT L R FM 75 UNBAL SYSTEM CONNECTOR ANTENNA 3 1 2 L R ANALOG OPTICAL COAXIAL DOCK INPUT R L SPEAKERS Video camera English 11 En Connection Connecting a Yamaha iPod universal dock This system is equipped with the DOCK terminal that allows you to connect a Yamaha iPod universal dock (such as the YDS-10, sold separately) where you can station your iPod and control playback of your iPod using the supplied remote control. Connect a Yamaha iPod universal dock to the DOCK terminal of the subwoofer/system control using its dedicated cable. Yamaha iPod universal dock (such as the YDS-10, sold separately) FM 75 UNBAL SYSTEM CONNECTOR ANTENNA 3 1 2 L R ANALOG OPTICAL COAXIAL DOCK INPUT R L SPEAKERS Connecting the indoor FM antenna To enjoy FM radio broadcast, connect the supplied indoor FM antenna. Indoor FM antenna (supplied) y FM 75 UNBAL SYSTEM CONNECTOR ANTENNA 3 1 2 L R ANALOG OPTICAL COAXIAL DOCK INPUT R L If the radio wave reception is weak in your area or you want to improve the radio wave reception, we recommend that you use outdoor antennas. For details, consult the nearest authorized Yamaha dealer or service center. SPEAKERS Connecting the power cable After you made all connections, connect the power cable of the subwoofer/system control. FM 75 UNBAL SYSTEM CONNECTOR ANTENNA 3 1 2 L To AC wall outlet OPTICAL COAXIAL R ANALOG DOCK INPUT R L SPEAKERS 12 En Basic playback operation Basic playback operation Once you have finished all cable connections (see pages 9 to 12) and remote control preparation (page 6), follow the procedure below to start basic playback operation. 1 Press STANDBY/ON. the power indicator lights up. To set this system to the This system turns on and standby mode, press STANDBY/ON again. y This system has the auto-sleep function which automatically switches to the standby mode if you do not operate this system for about 24 hours while this system is turned on. Enjoy Sounds an input 2 Press one of the input buttons to selectthe INPUT 1source. the subwoofer/ For example, if a DVD player is connected to jack of system control, press INPUT 1 to select the DVD player. y You can also switch the input source by pressing INPUT repeatedly. The input source changes as follows: BASIC OPERATION INPUT 1 INPUT 2 INPUT 3 DOCK FM on the selected external component. 3 Start playbackon the external component, refer to the manual for the product. For information 4 Press VOLUME +/­ to adjust the volume level. y To turn off the volume temporarily, press MUTE. [. . . ] With an additional channel especially for bass effects (called LFE, or low frequency effect), the system has a total of 5. 1-channels (LFE is counted as 0. 1 channel). By using 2-channel stereo for the surround speakers, more accurate moving sound effects and surround sound environment are possible than with Dolby Surround. 28 En Additional information Specifications YAS-70CU · Type . . . . . . . . . . . Full range acoustic suspension magnetic shielding type · Driver (Full range) . . . . . . . . . . . . . . . . . . . . . . . . 5 cm (2") cone magnetic shielding type × 6 (L3, R3) · Frequency Response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100 Hz to 25 kHz · Input impedance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 · Maximum Input . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35 W · Sensitivity (2. 83 V, 1 m) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]