User manual YAMAHA YDP-88E

[. . . ] IMPORTANT Check Your Power Supply Make sure that your local AC mains voltage matches the voltage specified on the name plate on the bottom panel. In some areas a voltage selector may be provided on the bottom panel of the main keyboard unit near the power cord. Make sure that the voltage selector is set for the voltage in your area. A voltage selector is provided in some areas. [. . . ] The C3 key produces equal (50:50) balance between the two voices, while keys to the left of C3 increase the volume of the left voice in relation to the right voice, and keys to the right of C3 increase the volume of the right voice in relation to the left voice. By "left" and "right" voice we refer to the relative positions of the voice selectors -- i. e. in a HARPSICHORD/ORGAN combination HARPSICHORD is the left voice and ORGAN is the right voice. Default Settings Voice Combinations Balance keys PIANO/ORGAN . . . . . . . . . . . . . . . . . . . . . . . "Transposing" the pitch of the YDP-88 keyboard facilitates playing in difficult key signatures, and you can easily match the pitch of the keyboard to the range of a singer or other instrumentalist. The [TRANSPOSE] button and keys F#2 through F#3 on the keyboard are used for transposition. F#2 TRANSPOSE C3 +1 +3 F#3 +6 -6 -4 -2 Z Press and hold the [TRANSPOSE] button. X Press a key between F#2 and F#3 according to the desired amount of transposition. * -5 -3 -1 0 +2 +4 +5 Transpose Transpose down. Normal pitch. C Release the [TRANSPOSE] button. * Pressing the C3 key produces normal keyboard pitch. Pressing the key to the left of C3 (B2) transposes the pitch of the keyboard down a semitone, the next key to the left (Bb2) transposes down a whole tone (two semitones), etc. , down to the F#2 key which transposes down 6 semitones. Upward transposition is accomplished in the same way using the keys to the right of C3, up to F#3 which transposes up 6 semitones. NOTE · Notes below and above the A-1 -- C7 of the YDP-88 sound one octave higher and lower, respectively. 6 Pitch Control Pitch control makes it possible to tune the YDP-88 over a ±50-cent range (approximate) in approximately 1. 6-cent intervals. A hundred "cents" equals one semitone, so the tuning range provided allows fine tuning of overall pitch over a range of approximately a semitone. Pitch control is useful for tuning the YDP-88 to match other instruments or recorded music. q Tuning Up A-1 B-1 C3 B3 Z To tune up (raise pitch), hold the A-1 and B-1 keys simultaneously. Each time a key in this range is pressed the pitch is increased by approximately 1. 6 cents, up to a maximum of 50 cents above standard pitch. C Release the A-1 and B-1 keys. q Tuning Down A#-1 A -1 C3 B3 Z To tune down (lower pitch), hold the A-1 and A#-1 keys simultaneously. X Press any key between C3 and B3. Each time a key in this range is pressed the pitch is decreased by approximately 1. 6 cents, up to a maximum of 50 cents below standard pitch. C Release the A-1 and A#-1 keys. q To Restore Standard Pitch* A#-1 A -1 B -1 C3 B3 Z To restore standard pitch (A3 = 440 Hz), hold the A-1, A#-1 and B-1 keys simultaneously. X Press any key between C3 and B3. C Release the A-1, A#-1 and B-1 keys. * Standard pitch (A3 = 440 Hz) is set when the [POWER] switch is initially turned ON. 7 The Metronome & Tempo Control The YDP-88 built-in metronome is a convenient feature for practice, and it can also provide a solid rhythmic guide when recording using the Recorder feature, described below. The Metronome METRONOME The metronome sound is turned on and off via the [METRONOME] button. Press the [METRONOME] button so that its indicator lights to turn the metronome on, then again so the indicator goes out to turn the metronome off. The volume of the metronome sound can be independently adjusted by using the [TEMPO] control while holding the [METRONOME] button. Sliding the control to the right increases the metronome volume. q Metronome Volume METRONOME 32 TEMPO 120 280 q Metronome Time Signature HARPSICHORD The time signature of the metronome sound can be set by pressing the appropriate voice selector button while holding the [METRONOME] button, as follows: METRONOME PIANO E. PIANO 2 ORGAN [METRONOME] + [PIANO] [METRONOME] + [E. PIANO 2] [METRONOME] + [HARPSICHORD] [METRONOME] + [ORGAN] No accent (default) 2 time 3 time 4 time 6 time Tempo Control 32 TEMPO 120 280 The tempo of the metronome and recorder playback can be controlled in two ways: s Use the panel [TEMPO] control to set the required tempo from 32 to 280 quarter-note beats per minute. METRONOME s For more precise tempo settings press the appropriate key on the keyboard while holding the [METRONOME] button. Tempo/Key Chart Key A-1 A#-1 B-1 C0 C#0 D0 D#0 E0 F0 F#0 G0 Tempo 32 34 36 38 40 42 44 46 48 50 52 Key G#0 A0 A#0 B0 C1 C#1 D1 D#1 E1 F1 F#1 Tempo 54 56 58 60 62 64 66 68 70 72 74 Key G1 G#1 A1 A#1 B1 C2 C#2 D2 D#2 E2 F2 Tempo 76 78 80 82 84 86 88 90 92 94 96 Key F#2 G2 G#2 A2 A#2 B2 C3 C#3 D3 D#3 E3 Tempo 98 100 102 104 106 108 110 112 114 116 118 Key F3 F#3 G3 G#3 A3 A#3 B3 C4 C#4 D4 D#4 Tempo 120 122 124 126 128 130 132 134 136 138 140 Key E4 F4 F#4 G4 G#4 A4 A#4 B4 C5 C#5 D5 Tempo 142 144 146 148 150 152 154 156 158 160 164 Key D#5 E5 F5 F#5 G5 G#5 A5 A#5 B5 C6 C#6 Tempo 168 172 176 180 184 188 192 196 200 204 208 Key D6 D#6 E6 F6 F#6 G6 G#6 A6 A#6 B6 C7 Tempo 212 216 220 224 232 240 248 256 264 272 280 8 Using the Recorder The YDP-88 recorder lets you record what you play on the keyboard and then play it back. This is a useful adjunct to any keyboard study program, since it lets you hear exactly how you sound from the listener's perspective. The recorder actually records the following data: q Notes played q Damper pedal q Voice selection q Left pedal q Dual mode voices q Dual balance q Tempo (Initial setting only. ) Recording Engage Z Mode the Record Ready RECORDER PLAY REC Press the RECORDER [REC] button to engage the record ready mode (recording does not actually start yet). [. . . ] Objects have fallen, been inserted, or liquids have been spilled into the enclosure through openings; or c. The product has been exposed to rain: or d. The product dose not operate, exhibits a marked change in performance; or e. The product has been dropped, or the enclosure of the product has been damaged. 3. [. . . ]