User manual YAMAHA YP-700

[. . . ] Proceed with the "OIL LEVEL CHECKING" items 1. Remove the oil filler cap and oil drain plug so that the oil can be completely drained. Check the drain plug gasket and oil filler cap a-ring. If damaged, replace it. CD O-ring <Z) Gasket I 4. [. . . ] 0W-~ 1 ~ ENGINE OIL 8-541 , I 5W~30I I 0c, -20 -30 -20 02040 -10 0 Oil level checking 1. Place the machine on a level surface and warm up the engine for several minutes. Make sure the engine oil is between upper and lower levels. Add oil as necessary. CD Upper level <Z) Lower level Recommended engine oil classification; API Service "SE" or "SF" if not available, "SD". Be -31- sure no foreign material l -32- enters the crankcase. 8-576 AUGER GEAR OIL Replacement 4. Drain Plug: 31 Nm (3. 1 m-kg, 22. 4 ft-Ib) NOTE: Recommended gear oil classification; API Service "SE" or "SF" if not available, "SD". · · Be sure the main switch key and spark plug lead are removed or disconnected before replacement. Be sure the auger and impeller have stopped before replacement. · · 1. Remove the oil drain plug so that the oil can be completely drained. If damaged, replace it. CD Gasket 3. Recommended Oil: SAE #90 Gear Oil Quantity: 80 cm3 (2. 8 Imp OZ, 2. 7 US OZ) · 8-586 Be sure no foreign material enters the crankcase. Place the machine so that the handlebar is up and auger housing is down when adding gear oil. Be sure the machine is securely placed. SKID (Auger Clearance) ADJUSTMENT · · Be sure the main switch key and spark plug lead are removed or disconnected before adjusting. Turn the adjusters in or out until proper track deflection is achieved. CD ~ Locknut Adjuster 3. Tighten the locknuts. -39- -40- (' G-600 G-650 FUEL FILTER WARNING: TROUBLESHOOTING G-651 Never use or be near the fuel and solvent while smoking or in the vicinity of an open flame. G-601 II Fuel cock 1. Remove the filter cup, gasket, and filter screen. Clean the filter screen and bottom of the filter cup with solvent. Wipe the filter cup and insert it with filter screen and gasket. G-620 Fuel tank filtc!;'r 1. Remove the fuel tank cap and filter. CD Filter -41- 2. Wipe the filter and insert it. WARNING: Be sure the tank cap is tightened securely. Engine won't start 1. Fuel systems No fuel supplied to combustion chamber. o No fuel in tank Supply fuel o Clogged fuel line Clean fuel line , 0 Foreign matter in fuel cock Clean fuel cock o Clogged carburetor Clean carburetor 2. Electrical systems Poor spark o Spark plug dirty with carbon or wet. . . . Remove carbon or wipe spark plug dry o Faulty ignition system Consult dealer 3. [. . . ] Pull the recoil starter until you feel compression. (This prevents the cylinder and valves from rust. ing. ) 704-001 G-701 B-716 DRAIN THE FUEL Drain the fuel tank, fuel cock, and carburetor float bowl. Pour a cup of SAE 10W30 or 20W40 motor oil into the tank, shake the tank to coat the inner surfaces thoroughly and drain off the excess oil. CHASSIS 1. [. . . ]