User manual YAMAHA YPP45E

[. . . ] This product may also use "household" type batteries. Make sure that the battery being charged is a rechargeable type and that the charger is intended for the battery being charged. When installing batteries, do not mix batteries with new, or with batteries of a different type. Mismatches or incorrect installation may result in overheating and battery case rupture. WARNING: Do not place this product in a position where anyone could walk on, trip over , or roll anything over power or connecting cords of any kind. [. . . ] If not, press the corresponding track button(s) so that they are lit. Then press the SONG [START/STOP] button. Playback starts from the beginning of the recorded data, and will stop automatically at the end of the recorded data. You can also stop playback at any time by pressing the SONG [START/STOP] button. To mute a track so that it doesn't play back, press the corresponding track button so that its indicator goes out (press again to turn the track back on). The current measure number appears on the display during playback. · It is possible to play along on the keyboard during playback. In this case, the playback voice and the voice you play on the keyboard are not the same. The playback voice is the voice that was set when the data was recorded. The voice you play on the keyboard is the voice that is selected on the panel. · The playback volume and tempo can be adjusted by using the [MASTER VOLUME] control and [TEMPO/FUNCTION M, L] buttons (press both [TEMPO/FUNCTION M, L] buttons simultaneously to recall the default tempo). · All user song recorder data will be retained in memory for about one week after the power is turned off. Soft Pedal Mode. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Metronome Volume . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Preset Song Part Cancel Volume . . . . . . . . . . . . . . . . . . . . . . . . . . MIDI Functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Backup Functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 27 28 29 29 29 30 33 To Select a Function . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Z Press the [FUNCTION] button so that its indicator lights. · Functions cannot be selected during demo/preset song playback or when the user song recorder is in operation. X Use the [TEMPO/FUNCTION t, s] buttons to select the desired function: F1 through F8. C In the case of the Scale (F2), Dual Mode (F3), MIDI (F7), and G Operation Example Backup (F8) functions, you will have to press the [+/YES] button once to enter the respective sub-mode after the function has been selected, and then use the [TEMPO/FUNCTION t, s] buttons again to select the desired sub-function. · The Dual mode must be engaged before the F3 function can be selected. If the Dual mode is not engaged, "F3. -" will appear on the display and the sub-mode will not be available. Press [+/YES] (sub-mode) Use [TEMPO/ FUNCTION t, s] V Set the function as required by using the [­/NO] and [+/YES] buttons (see the individual function descriptions, below). · After selecting the function, the current setting will be displayed when the [­/NO] or [+/YES] button is pressed for the first time. Press [­/NO] or [+/YES] once B Press the [FUNCTION] button so that its indicator goes out to exit from the function mode. Use [­/NO], [+/YES] YPP-200 26 The Function Mode F1 Tuning After selecting "F1", use the [­/NO] and [+/YES] buttons to lower or raise the pitch in approximately 0. 2 Hz increments (the first time the [­/NO] or [+/YES] button is pressed simply switches to the tuning value display without actually changing the tuning). The overall tuning range is from 427. 0 Hz to 453. 0 Hz (corresponding to the A3 note's Hz). Press the [­/NO] and [+/YES] buttons simultaneously to recall the default value "440 Hz". Tenths of a Hertz are indicated on the LED display by the appearance and position of one or two dots, as in the following example: Display 440 4. 40 44. 0 440. [. . . ] 4, Jakarta 12930, Indonesia Tel: 21-520-2577 GREECE Philippe Nakas S. A. Navarinou Street 13, P. Code 10680, Athens, Greece Tel: 01-364-7111 CENTRAL & SOUTH AMERICA MEXICO Yamaha de Mexico S. A. De C. V. , Departamento de ventas Javier Rojo Gomez No. 1149, Col. Tel: 686-00-33 KOREA Cosmos Corporation 1461-9, Seocho Dong, Seocho Gu, Seoul, Korea Tel: 02-3486-0011 SWEDEN Yamaha Scandinavia AB J. [. . . ]