User manual YAMAHA YPP50

[. . . ] IMPORTANT Check your power supply Make sure that your local AC mains voltage matches the voltage specified on the name plate on the bottom panel. In some areas a voltage selector may be provided on the rear panel of the main keyboard unit. Make sure that the voltage selector is set for the voltage in your area. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. See bottom of keyboard enclosure for graphic symbol markings The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. IMPORTANT SAFETY AND INSTALLATION INSTRUCTIONS INFORMATION RELATING TO POSSIBLE PERSONAL INJURY, ELECTRIC SHOCK, AND FIRE HAZARD POSSIBILITIES HAS BEEN INCLUDED IN THIS LIST. using WARNING --When shouldelectronic products, basic precautions always be followed, including the following: a stand. [. . . ] The amount of variation available depends on the selected voice. 3. The demonstration music will begin playing as soon as you press the DEMO button. The demonstration will play continuously, providing samples of different voices, until the DEMO button is pressed a second time. TRANSPOSITION The Personal Electronic Piano's TRANSPOSE function makes it possible to shift the pitch of the entire keyboard up or down in semitone intervals up to a maximum of six semitones. "Transposing" the pitch of the Personal Electronic Piano keyboard makes it easier to play in difficult key signatures, and you can simply match the pitch of the keyboard to the range of a singer or other instrumentalist. The MIDI/TRANSPOSE button and TEMPO and buttons are used for transposition. Press and hold the MIDI/TRANSPOSE button. Press the TEMPO or button as many times as necessary to produce the desired degree of transposition. Each time the TEMPO o r button is pressed the pitch of the keyboard is transposed by one semitone in the specified direction (i. e. Pitch can be transposed up or down by a maximum of six semitones. * 3. Release the MIDI/TRANSPOSE button. l A different voice or tempo can be selected at any time while the demonstration is playing (refer to the appropriate sections of this manual for instructions). Voice changes, however, will only remain in effect until the next automatic voice change. PLAYING THE PERSONAL ELECTRONIC PIANO After making sure that the Personal Electronic Piano's AC plug is properly inserted into a convenient AC wall outlet: 1. Press the POWER switch located to the left of the keyboard to turn the power ON. When the power is turned ON, the PIANO voice selector LED will light (the PIANO voice is automatically selected whenever the power is turned ON). * Pressing both the TEMPO and buttons simultaneously while the MIDI/TRANSPOSE button is held produces normal keyboard pitch. 8 PITCH CONTROL Pitch control makes it possible to tune the Personal Electronic Piano over a ±50-cent range in approximately 3-cent intervals. A hundred "cents" equals one semitone, so the tuning range provided allows fine tuning of overall pitch over a range of approximately a semitone. Pitch control is useful for tuning the Personal Electronic Piano to match other instruments or recorded music. To tune up (raise pitch), hold the E0 and F0 keys simultaneously. Each time a key in this range is pressed the pitch is increased by approximately 3 cents, up to a maximum of 50 cents above standard pitch. To tune down (lower pitch), hold the E0 and F #0 keys simultaneously. Each time a key in this range is pressed the pitch is decreased by approximately 3 cents, up to a maximum of 50 cents below standard pitch. To restore standard pitch (A3 = 440 Hz), hold the E0, F0 and F#0 Tkeys simultaneously. Release the E0, F0 and F#0 keys. * Standard pitch (A3 = 440 Hz) is automatically set whenever the POWER switch is initially turned ON. Note: Recording can not be activatedif the YPP-60 Multi-Timbre Mode is engaged (see "The Multi-Timbre Mode" in the "MIDI FUNCTIONS" section of this manual-page 101. Recording 1. Set the Record Ready Mode Press the PERFORMANCE MEMORY REC button. [. . . ] Digital Reverb These state-of-the-art Expander Modules can dramatically expand the musical scope of your Personal Electronic Piano. NOTE: Some items may not be available in certain areas. 3 . PROGRAM CHANGE Data format: [CnH]­>[dd] CnH = program event (n = channel number) dd = Program number dd VOICE dd VOICE 08H PIANO + BASS PIANO 00H 0 9 H E. PIANO + BASS 0lH E. PIANO 02H HARPSI 0AH HARPS1 + BASS 0BH VIBES + BASS 03H VIBES 0CH BRASS + BASS 04H BRASS 0DH STRINGS + BASS 05H STRINGS 06H 0EH P. ORGAN + BASS P. ORGAN 07H BASS * No voice change is made when dd>0EH. 4. SYSTEM REALTIME MESSAGES Active Sensing (FEH) Transmitted every 200 milliseconds. If not received for more than 400 milliseconds a NOTE OFF occurs. [. . . ]