User manual YAMAHA YPR-20

[. . . ] Cable/s supplied with this product MUST be used. Failure to follow instructions could void your FCC authorization to use this product in the USA. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class "B" digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with other electronic devices. [. . . ] If the currently-selected library memory contains Input Channel 1­32 and ST IN Channels 1­4 settings, its Surround mode and Aux pairing information are also displayed below this parameter. 2 Use the LAYER buttons to select layers, then press the [SEL] buttons to select channels. For details on the Store and Recall functions, see "General Library Operation" on page 175. If the selected memory's channel type does not match the type of the destination channel, an alarm mark ( ) and the word "CONFLICT" appear next to the STORED FROM parameter. These alarms indicate that you tried to recall unrecallable channel settings to the currently-selected channel. 16 Libraries YPR-20 Version 2--Owner's Manual 178 Chapter 16--Libraries The alarm indicators also appear when the Surround mode, Aux pair, and other non-channel parameter settings originally stored in the memory do not match those for the destination channel. However, if the channel type of the memory and that of the destination channel match, you can recall the settings even with the alarm indicators displayed. (For unmatched parameter settings, the YPR-20 will use the settings in the memory that is to be recalled. ) The following preset memories are available for the Channel library. No. 0 1 Preset Name Reset (­ dB) Reset (0 dB) Description This preset memory resets all parameters of the currently-selected channel to their initial values and sets the channel fader level to (­ dB). This preset memory resets all parameters of the currently-selected channel to their initial values and sets the channel fader level to 0 dB (i. e. , nominal). Input Patch Library The Input Patch library enables you to store and recall all Input Patch settings. The library contains one preset memory and 32 user (readable & writable) memories. To access the Input Patch library, press the DISPLAY ACCESS [PATCH] button repeatedly until the Patch | IN LIB page appears. Delay+Rev Delay->Rev Dist->Delay Type REV+CHORUS REV->CHORUS REV+FLANGE REV->FLANGE REV+SYMPHO. DELAY+REV DELAY->REV DIST->DELAY Description Reverb and chorus in parallel Reverb and chorus in series Reverb and flanger in parallel Reverb and flanger in series Reverb and symphonic in parallel Reverb and symphonic in series Reverb and auto-pan in series Delay and early reflections in parallel Delay and early reflections in series Delay and reverb in parallel Delay and reverb in series Distortion and delay in series · Others No. 41 42 43 44 Preset Name Multi. Filter Freeze Stereo Reverb M. Band Dyna. Type MULTI. FILTER FREEZE ST REVERB M. BAND DYNA. Description 3-band parallel filter (24 dB/octave) Simple sampler (Available for internal effects 1 and 2. ) Stereo reverb 3-band dynamics processor · Add-On Effects No. 451 461 471 481 491 501 511 521 531 Preset Name Comp276 Comp276S Comp260 Comp260S Equalizer601 OpenDeck REV-X Hall REV-X Room REV-X Plate Type COMP276 COMP276S COMP260 COMP260S EQUALIZER601 OPENDECK REV-X HALL REV-X ROOM REV-X PLATE -- Description 1. These preset programs are dedicated to Add-On Effects. The numbers of effects programs that do not have Add-On Effects installed are grayed out and cannot be used. For more information on Add-On Effects, refer to "About Add-On Effects" on page 162. YPR-20 Version 2--Owner's Manual Using Libraries 183 Gate Library The Gate library enables you to store and recall Input Channel gate settings. The library contains four preset memories and 124 user (readable & writable) memories. Follow the steps below to use the Gate library. [. . . ] Output [+24dBu] +24 +20 +10 +4 0 ­10 ­20 ­30 [+4dBu] Nominal Input GAIN MIN. , PAD ON Nominal Output [+4dBu] [-2dBu] STEREO OUT OMNI OUT MONITOR OUT Max. Input [-40dBu] ­40 ­50 Nominal [-60dBu] Input GAIN MAX. , PAD OFF ­60 ­70 ­80 ­90 ­100 ­110 ­120 ­130 ­140 ­150 ­160 DSP Noise Floor ­170 ­180 ­190 [0dBu = 0. 775Vrms] [0dBFS = Full Scale] For details of products, please contact your nearest Yamaha representative or the authorized distributor listed below. Pour plus de détails sur les produits, veuillez-vous adresser à Yamaha ou au distributeur le plus proche de vous figurant dans la liste suivante. Die Einzelheiten zu Produkten sind bei Ihrer unten aufgeführten Niederlassung und bei Yamaha Vertragshändlern in den jeweiligen Bestimmungsländern erhältlich. Para detalles sobre productos, contacte su tienda Yamaha más cercana o el distribuidor autorizado que se lista debajo. NORTH AMERICA CANADA Yamaha Canada Music Ltd. [. . . ]