User manual YAMAHA YS-624WE SUPPLEMENTARY SERVICE MANUAL

[. . . ] 1) To obtain warranted service, you will be required to provide to either Onga state office or recommended service agent:a) the product; b) confirmation in writing specifying the nature of your claim; c) proof providing date of original purchase; d) full contact details including name and address; e) the serial number of the product if any. 2) The product is to be forwarded by the customer freight paid to an Authorised Onga service agent. Infield service by an authorised Onga Service Agent will incur a travel, removal & reinstallation fee to adjudicate on warranty issues. Authorised warranty will be free of charge for the first 12 month period from date of the first consumer purchase. [. . . ] Use equipment only in a pool or spa installation. Install pump with at least 2 hydraulically balanced main drains equipped with correctly installed, screw-fastened, anti-entrapment certified covers according to local regulations. Trapped air in system can cause explosion. Ensure all air is out of system before operating or testing equipment. Blown fuse Automatic thermal overload has tripped to protect the motor. Pump operates with reduced or no flow Pump is jammed (check if shaft is free to rotate). Motor burnt out due to voltage spike or flooded by water. Valves turned to the closed position. 3. Dirty filter. Air ingress to system. Lack of water. Debris in the pump or skimmer box. (Note: Do not operate the pump without hair & lint pot or skimmer basket correctly fitted). Fire and burn hazard. To reduce risk of fire, do not allow leaves, debris, or foreign matter to collect around the pump motor. To avoid burns when handling the motor, let it cool for at least 20 minutes before trying to work on it. A thermal overload switch protects the motor from heat damage during operation. Pump leaking from between the casing and the motor. Casing bolts are not tight. NOTICE: To prevent flooding when removing pump for service, all flooded suction systems must have shut-off valves in suction and discharge pipes. Fittings: Fittings restrict flow; for best efficiency use fewest possible fittings. Avoid fittings which could cause an air trap. Pool outlets: Use only non-entrapping suction fittings or double suction conforming with the AS1926. 3-2003 Standard, or local authority requirements. 3. 4. 6. Pump Service Pump should only be serviced by qualified personnel. For best results, use only genuine Onga factory parts. Be sure to prime pump before starting. Before removing hair & lint pot lid: 1. SWITCH OFF POWER to pump before proceeding. CLOSE SHUT-OFF VALVES in suction and discharge pipes. RELEASE ALL PRESSURE from pump and piping system. NEVER tighten or loosen lid while pump is operating! To avoid dangerous or fatal electrical shock hazard, turn OFF power to motor and remove plug from power outlet before working on pump or motor. No lubrication or regular maintenance is needed beyond reasonable care and periodic cleaning of strainer basket. [. . . ] Entrapment Protection The pump suction system must provide protection against the hazard of suction entrapment or hair entrapment/entanglement. Suction Outlet Covers All suction outlet covers must be maintained. They must be replaced if cracked, broken, or missing. See below for outlet cover certification requirements. [. . . ]