User manual YAMAHA YST-SW015

[. . . ] UB YST -SW01 5 Subwoofer System OWNER'S MANUAL IMPORTANT SAFETY INSTRUCTIONS 1 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN Read these instructions. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] This unit features a magnetically shielded design, but there is still a chance that placing it too close to a TV set might impair picture color. Should this happen, move this unit away from the TV set. E-1 CONTENTS IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . and Europe models . . . . . . . . . . . . . . . . . . . . . . . . AC 230V, 50 Hz Australia model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 240V, 50 Hz China, Korean and General models . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 110-120/220-240V, 50/60 Hz Dimensions (W x H x D) . . . . . 280 mm x 325 mm x 320 mm (11" x 12-13/16" x 12-5/8") Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 oz. ) Power Consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 70 W Standby Power Consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0. 8 W * Specifications are subject to change without notice due to product improvements. E-2 PLACEMENT Å i English ( : subwoofer, : main speaker) It is recommended to place the subwoofer on the outside of either the right or the left main speaker. i is also possible, however, if the subwoofer system is placed directly facing the wall, the bass effect may die because the sound from it and the sound reflected by the wall may cancel out each other. To prevent this from happening, face the subwoofer system at an angle as shown in fig. Note There may be a case that you cannot obtain enough superbass sounds from the subwoofer when listening in the center of the room. This is because "standing waves" have been developed between two parallel walls and they cancel the bass sounds. In such a case, face the subwoofer obliquely to the wall. It also may be necessary to break up the parallel surfaces by placing bookshelves etc. along the walls. Use the non-skid pads Put the provided non-skid pads at the four corners on the bottom of the subwoofer to prevent the subwoofer from moving by vibrations etc. SUBWOOFER STANDBY/ON SYSTEM B. A. S. S. YST-SW015 VOLUME 0­10 HIGH CUT50­150Hz I About this manual · This manual is printed prior to production. Design and specifications are subject to change in part for the reason of the improvement in operativity ability, and others. · Some of the illustrations and names of the package contents etc. written in this manual may differ from the actual products and the names written on the package etc. E-3 CONNECTIONS Caution: Plug in the subwoofer and other audio/video components after all connections are completed. Connect the subwoofer to the line output (pin jack) terminal(s) of the amplifier. When connecting the subwoofer to the SPLIT SUBWOOFER terminals on the rear of the DSP amplifier, be sure to connect the L/MONO INPUT terminal to the "L" side and the R INPUT terminal to the "R" side of the SPLIT SUBWOOFER terminals. To connect with a YAMAHA DSP amplifier (or AV receiver), connect the SUBWOOFER (or LOW PASS etc. ) terminal on the rear of the DSP amplifier (or AV receiver) to the L/MONO INPUT terminal of the subwoofer. Right main speaker Left main speaker Subwoofer cable (not included) Subwoofer INPUT /MONO AUTO STANDBY PHASE OFF LOW HIGH NORM REV INPUT /MONO AUTO STANDBY PHASE OFF LOW HIGH NORM REV 110V­120V 220V­240V VOLTAGE SELECTOR POWER ON OFF To AC outlet Audio pin cable (not included) SPLIT SUBWOOFER Amplifier SUBWOOFER (LOW PASS) Notes Some amplifiers have line output terminals labeled PRE OUT. [. . . ] Play a source sound with bass frequencies. Set the HIGH CUT control to a higher position. Reposition the subwoofer or break up the parallel surface by placing bookshelves etc. Set the POWER switch to the ON position. [. . . ]