User manual YAMAHA YT3000

[. . . ] A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] The cabinet should never be opened for any reasons. 15 When not planning to use this unit for long periods of time (i. e. vacation), disconnect the AC power plug from the wall outlet. 16 Be sure to read the "TROUBLESHOOTING" section on common operating errors before concluding that this unit is faulty. 17 Before moving this unit, press to set the system to off, and disconnect the AC power plug from the wall outlet. 18 Condensation will form when the surrounding temperature changes suddenly. Disconnect the power cable from the outlet, then leave this unit alone. 19 When using this unit for a long time, this unit may become warm. Turn the system off, then leave this unit alone for cooling. 20 Install this unit near the wall outlet and where the AC power plug can be reached easily. 21 The batteries shall not be exposed to excessive heat such as sunshine, fire or the like. 5) 0 DIMMER: Setting brightness of the front panel A (auto) 3 (brightest) 2 1 (darkest) back to A y · Press and hold on the top of the unit for more than 3 seconds to set the system to standby mode. All the information on the front panel display is not displayed in standby mode. · Even in system off/standby mode, the alarm function is available. 4) 5 Front panel display 6 SOURCE: iPod, AUX, RADIO 7 VOLUME: Volume control y When A (auto) is set, the brightness of the front panel is adjusted automatically depending on the brightness of the room. 7) C FM, AM: Switching FM/AM D iPod dock: Set an iPod. y Cover the iPod dock with the dock cover when not using. E Illumination sensor: Measuring surrounding illuminance. Do not cover this sensor. 2 En NAMES OF PARTS AND THEIR FUNCTIONS English Rear panel Antenna terminal (See below. ) 15V : Connect supplied AC adaptor and power cable. 4) TONE CONTROL: Control Bass and Treble. Connecting antennas Indoor FM antenna (supplied) AM loop antenna (supplied): Connect the black cord to GND, and the white to AM ANT. Notes · The antenna should be stretched out. · If radio reception is poor, change the height, direction, or placement of the antenna. · If you use outdoor antennas instead of the supplied antennas, reception will be better. Ground (GND terminal): For minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth. Remote control Source buttons: iPod, AUX, RADIO. [. . . ] Clock flashes and the unit cannot be operated. The unit is left more than one week after Plug the power cable into the wall outlet you disconnect the power cable from the firmly, and set the clock again ( P. CLOCK on the rear panel is set to SET, and this unit is in clock setting mode. Set ALARM TYPE to SOURCE+BEEP or SOURCE ( P. Set CLOCK to LOCK. iPodTM Problem No sound Cause The iPod is not set in the iPod dock firmly. [. . . ]