User manual YAMAHA YZF-R1-2002

[. . . ] OWNER'S MANUAL YZF-R1 5PW-28199-E0 EAU03338 INTRODUCTION Welcome to the Yamaha world of motorcycling!As the owner of a YZF-R1, you are benefiting from Yamaha's vast experience and newest technology regarding the design and manufacture of high-quality products, which have earned Yamaha a reputation for dependability. Please take the time to read this manual thoroughly, so as to enjoy all advantages of your YZF-R1. The owner's manual does not only instruct you in how to operate, inspect and maintain your motorcycle, but also in how to safeguard yourself and others from trouble and injury. [. . . ] Check the coolant level in the coolant reservoir. NOTE: The coolant should be between the minimum and maximum level marks. _ _ Coolant The coolant level should be checked before each ride. In addition, the coolant must be changed at the intervals specified in the periodic maintenance and lubrication chart. Place the motorcycle on a level surface and hold it in an upright position. 6 11. Turn the engine off, and then check the oil level and correct it if necessary. If the coolant is at or below the minimum level mark, remove panel A (See page 6-7 for panel removal and installation procedures. ), remove the reservoir cap, add coolant to the maximum level mark, and then install the reservoir cap and the panel. Coolant reservoir capacity: 0. 24 L 6-12 PERIODIC MAINTENANCE AND MINOR REPAIR EC000080 _ 6 CAUTION: G If coolant is not available, use distilled water or soft tap water instead. Do not use hard water or salt water since it is harmful to the engine. G If water has been used instead of coolant, replace it with coolant as soon as possible, otherwise the engine may not be sufficiently cooled and the cooling system will not be protected against frost and corrosion. G If water has been added to the coolant, have a Yamaha dealer check the antifreeze content of the coolant as soon as possible, otherwise the effectiveness of the coolant will be reduced. EW000067 NOTE: G The radiator fan is automatically switched on or off according to the coolant temperature in the radiator. G If the engine overheats, see page 6-46 for further instructions. _ _ 1. Radiator cap EAU04524 _ WARNING Never attempt to remove the radiator cap when the engine is hot. _ _ To change the coolant 1. Place the motorcycle on a level surface and let the engine cool if necessary. (See pages 6-5­6-7 for cowling and panel removal and installation procedures. ) 3. Place a container under the engine to collect the used coolant. Remove the radiator cap and coolant reservoir cap. EW000067 WARNING Never attempt to remove the radiator cap when the engine is hot. _ 6-13 __ PERIODIC MAINTENANCE AND MINOR REPAIR 10. After the coolant is completely drained, thoroughly flush the cooling system with clean tap water. Install the coolant drain bolt, and then tighten it to the specified torque. NOTE: Check the washer for damage and replace it if necessary. _ _ 1. Remove the clutch cable holder from the coolant reservoir as shown. Remove the coolant reservoir by removing the bolts, and then turn the coolant reservoir upside down to empty it. Install the coolant reservoir by installing the bolts, and then install the clutch cable holder. 8. [. . . ] 7-4 Storage compartment . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-19 Supporting the motorcycle . . . . . . . . . . . . . . . . . . . . . 6-39 V Valve clearance, adjusting . . . . . . . . . . . . . . . . . . . . 6-19 Vehicle identification number. . . . . . . . . . . . . . . . . . . [. . . ]