User manual YAMAHA YZF1000RJC SERVICE MANUAL

[. . . ] We introduced our first HiFi (High Fidelity) turntable in 1954. Thereafter we were one of the first to offer mass-produced, high quality audio equipment, and introduced many legendary stereo components. We hope you enjoy the genuine HiFi experience of Yamaha Natural Sound. Excellence in Audio Achievement First HiFi System introduced in 1920 We introduced numerous HiFi components (turntables, FM/AM tuners, integrated amplifiers, preamplifiers, power amplifiers and speakers) in 1955 - 1965. Natural Sound Speaker Series introduced in 1967 NS-20 Monitor Speaker CA-1000 Integrated Amplifier Featuring A-Class operation, the CA-1000 set the standard for integrated amplifiers. NS-690 Monitor Speaker NS-1000M Monitor Speaker A truly legendary speaker still revered by HiFi enthusiasts. B-1 Power Amplifier An innovative power amp that used FETs in all stages. C-2 Control Amplifier Received top prize at the Milan International Music and HiFi Show NS-10M Studio Monitor Speaker Became of the most popular studio monitors in the world. A-1 Integrated Amplifier PX-2 Turntable Yamaha's first straight arm turntable. B-6 Power Amplifier Pyramid-shaped power amplifier. GT-2000/L Turntable First CD Player (CD-1) introduced in 1983 B-2x Power Amplifier MX-10000 Power Amplifier and CX-10000 Control Amplifier Redefined the capabilities of separate components. AX-1 Integrated Amplifier GT-CD1 CD Player MX-1 Power Amplifier and CX-1 Preamplifier Soavo-1 and Soavo-2 Natural Sound Speaker Systems A-S2000 Stereo Amplifier and YZF1000RJC Super Audio CD Player Full-stage balanced signal transmission achieves the ultimate in CD reproduction Full-stage balanced signal transmission beginning with the DAC Silent loader and high precision CD drive Independent power supplies with digital and analog completely separated Pure Direct Left-right symmetrical design with rigid, stable construction Super sound from Super Audio CDs Supplied accessories Please check that you have received all of the following parts. [. . . ] Do not put a normal 12-cm CD on top of an 8-cm CD. 20 En Troubleshooting Refer to the chart below if this unit does not function properly. If the problem you are experiencing is not listed below or if the instructions below do not help, turn off this unit, disconnect the AC power cable, and contact the nearest authorized Yamaha dealer or service center. Problem The unit does not switch ON when POWER is pressed upward. The disc tray does not close completely. Playback does not start. Cause The power cord is not connected nor completely connected. Remedy Securely connect the power cord. See page 16 A foreign object is obstructing the tray. The MP3 or WMA formats are not compatible with this unit. The CD-RW (ReWritable) disc is not recorded correctly. The disc is a non-standard disc not playable with this unit. Carefully check the disc tray and remove the foreign object. Check the disc carefully; replace it if necessary. Wait 20 to 30 minutes after switching the unit ON before trying to play back a disc. Replace the disc with a correctly recorded disc playable with this unit. Replace the disc with a correctly recorded disc playable with this unit. Retain this Owner's Manual in a safe place for future reference. FOR CANADIAN CUSTOMERS To prevent electric shock, match wide blade of plug to wide slot and fully insert. This Class B digital apparatus complies with Canadian ICES-003. 13 14 Read these instructions. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. [. . . ] Damage resulting from: (1) Repairs performed by the customer himself or by an unauthorised third party. (2) Inadequate packaging or mishandling, when the product is in transit from the customer. Please note that it is the customer's responsibility to ensure the product is adequately packaged when returning the product for repair. (3) Misuse, including but not limited to (a) failure to use the product for its normal purpose or in accordance with Yamaha's instructions on the proper use, maintenance and storage, and (b) installation or use of the product in a manner inconsistent with the technical or safety standards in force in the country where it is used. (4) Accidents, lightning, water, fire, improper ventilation, battery leakage or any cause beyond Yamaha's control. [. . . ]