User manual YAMAHA ZUMA LL-2000

[. . . ] If you have any questions concerning the operation or maintenance of your scooter, please consult a Yamaha dealer. IMPORTANT MANUAL INFORMATION Particularly important information is distinguished in this manual by the following notations: EAU00003 Q The Safety Alert Symbol means ATTENTION!Failure to follow WARNING instructions could result in severe injury or death to the scooter w operator, a bystander or a person inspecting or repairing the scooter. cC NOTE: A CAUTION indicates special precautions that must be taken to avoid damage to the scooter. A NOTE provides key information to make procedures easier or clearer. [. . . ] FRONT a 20 · b · 40 · 50 km/h 60· b 10 ·20 ·10 30 30 0 ·0 0000001 40 MPH a EAU00434 EAU00435 5 Acceleration and deceleration The speed can be adjusted by opening and closing the throttle. To increase the speed, turn the throttle grip in direction a. To reduce the speed, turn the throttle grip in direction b. Braking 1. Apply both front and rear brakes simultaneously while gradually increasing the pressure. EW000057 w 8 Avoid braking hard or suddenly (especially when leaning over to one side), otherwise the scooter may skid or overturn. 8 Railroad crossings, streetcar rails, iron plates on road construction sites, and manhole covers become extremely slip- 5-3 OPERATION AND IMPORTANT RIDING POINTS REAR EAU00436 EAUT0003 Engine break-in There is never a more important period in the life of your engine than the period between 0 and 1, 000 km (600 mi). For this reason, you should read the following material carefully. Since the engine is brand new, do not put an excessive load on it for the first 1, 000 km (600 mi). The various parts in the engine wear and polish themselves to the correct operating clearances. During this period, prolonged full-throttle operation or any condition that might result in engine overheating must be avoided. 0-150 km (0-100 mi) Avoid operation above 1/3 throttle. Stop the engine and let it cool for 5 to 10 minutes after every hour of operation. Vary the speed of the scooter from time to time. 9 Check operation and adjust brake lever free play. Whenever worn to the limit 8* Front brake 9* 10 * Rear brake Wheels Whenever worn to the limit 6-2 PERIODIC MAINTENANCE AND MINOR REPAIR No. 11 * Tires ITEM ROUTINE 9 Check tread depth and for damage. 9 Check bearing for looseness or damage. 9 Check bearing play and steering for roughness. 9 Lubricate with lithium-soap-based grease. INITIAL 10, 00 km (600 mi) EVERY 6, 000 km 3, 000 km (2, 000 mi) or (4, 000 mi) or 12 months 6 months 12 * 13 * Wheel bearings Steering bearings Every 12, 000 km (8, 000 mi) or 24 months(whichever comes first). 14 * 15 * 16 * 17 Front fork Shock absorber assembly Chassis fasteners Centerstand 9 Check operation and for oil leakage. 9 Check operation and shock absorber for oil leakage. 9 Replace shock absorber assembly if necessary. 9 Make sure that all nuts, bolts and screws are properly tightened. 9 Lubricate with lithium-soap-based grease(all-purpose grease). 6 * Since these items require special tools, data and technical skills, have a Yamaha dealer perform the service. 6-3 PERIODIC MAINTENANCE AND MINOR REPAIR EAU03057 NOTE: 8 The air filter needs more frequent service if you are riding in unusually wet or dusty areas. 8 Hydraulic brake system 9 When disassembling the master cylinder or caliper cylinder, always replace the brake fluid. Check the brake fluid level regularly and fill as required. [. . . ] However, NHTSA cannot become involved in individual problems between you, your dealer, or Yamaha Motor Corporation, U. S. A. To contact NHTSA, you may either call the Auto Safety Hotline toll-free at 1-800-424-9393 (or 366-0123 in Washington, D. C. Department of Transportation, Washington, D. C. You can also obtain other information about motor vehicle safety from the Hotline. 9 9-3 CONSUMER INFORMATION EAU01055 SCOOTER NOISE REGULATION TAMPERING WITH NOISE CONTROL SYSTEM PROHIBITED: Federal law prohibits the following acts or the causing thereof: (1) The removal or rendering inoperative by any person other than for purposes of maintenance, repair, or replacement of any device or element of design incorporated into any new vehicle for the purpose of noise control prior to its sale or delivery to the ultimate purchaser or while it is in use or (2) the use of the vehicle after such device or element of design has been removed or rendered inoperative by any person. [. . . ]