User manual ZALMAN GWB3

[. . . ] After no leakage is confirmed, proceed with installation and use. 2) Use approved coolant for computer water-cooling to prevent corrosion. 3) Use coolant tubes listed under the compatibility list. [. . . ] Exploded View Bolt GWB3 Ass'y Nipple Rubber Ring Washer Plate Spring Nut 3 5. Installation Procedure 1) Install Nipples and Fixing Nuts Insert the Nipples and Rubber Rings into the front side of the VGA card, then install the Washer Plate (PVC), Springs, and Fixing Nuts in the mentioned order. Note 1) Screw the Fixing Nuts only to a point so that the Fixing Nuts stay connected to the Nipples (approximately two screw turns). Note 2) The ends of the Springs are of different diameters. Install the Spring end with the shorter diameter on the Fixing Nut. Nipple Nut Spring Washer Plate 2) Thermal Grease Applycation Clean the contact surface of the VGA Chipset completely. Apply Thermal Grease on the VGA Chipset that makes contact with the base of theVGA Cooler. Spring Fixing Nut Thermal Grease 4 3) Installing the VGA Water Block Place the VGA Water Block and the clip on the center of the VGA chipset. Screw each bolt B on each nipple slightly, and tighten each bolt a few turns at a time while alternating between the two until the bolt ends are completely pressed against the Nipples. Note 1) Nipples and Fixing Nuts are not completely fixed on to each other, therefore hold the Nipple with one hand while screwing in the Bolts. Bolt Nipple 4) Control Tension between VGA Water Block and VGA Chipset Tighten/loosen the Fixing Nuts on the back side of the VGA card in order to control the tension between the VGA water block and VGA chipset. Note 1) If the Fixing Nuts are turned too tightly, then damage to the VGA chipset or VGA card could occur. Note 2) Fully tightening one Fixing Nut at a time may result in damaging the VGA chipset. Please tighten each Fixing Nut one rotation at a time until all are completely tightened. Note3) Make sure that the VGA Cooler does not interfere with the VGA card's capacitors and other components. Nut Washer Plate Spring 5 5) VGA Card Installation Insert the assembled VGA card into the motherboard's PCIe (or AGP) slot. Use the Fixing Bolt to secure the VGA card onto the computer case. If the VGA card has a power connector on it, remember to plug in th power cable. Fixing Bolt 6) Installing the Tubes and the Tube Clamps Plug the tubes over the VGA Water Block'sfittings and install the Tube Clamps. [. . . ] cutting nipper)when installing the Tube Clamps. Note 2) Hold the VGA or RAM water block with one hand to keep them from moving when installing the Tube. Note 3) Cutting the tubes to adequate length before-hand will simplify the process of connecting tubes to the VGA water block and RWB1 INLET OUTLETT 7 Zalman Noise Prevention System Stable performance and noiseless liquid cooling system can both be achieved with the use of Zalman's Noiseless Power Supply, HeatPipe Hard Disk cooler, Noiseless Case Fan and Northbridge Water Block. Noiseless Power Supply Heatpipe HDD Cooler Noiseless Case Fan Northbridge Water Block TNN(Totally No Noise) Computer Case TNN 300 TNN 500AF NN Computer Enclosures are the world's first environment-friendly noiseless computer enclosures that operate without the use of a fan. [. . . ]