User manual ZALMAN ZM-500GS

[. . . ] Specifications Name Weight Materials Dimensions Heat Dissipating Area NP Heatpipe HDD Cooler 270g Aluminum, Copper, Rubber 143. 5(L) X 146. 5(W) X 36. 5(H) mm 415 cm2 3. Patent Applications Patent Applications Pending in over 20 nations around the world, including the U. S. A. , EU, and Japan Korean Patent Applications : No. [. . . ] Compatible HDDs 3. 5-inch Hard Disk Drive for PCs Standard Size : 146 X 101. 6 X 25. 4 (20) mm 1 5. Exploded View Damper Heatpipe Al Bar Damper A-Type Bolt B-Type Bolt Ground Wire Mounting Hole Sticker Manual <Fig. Components Assembed NP Heatpipe HDD Cooler - Two (2) Al Bars - Eleven (11) Heatpipes Four (4) A-Type Bolts : For fastening the HDD Four (4) B-Type Bolts : For installing the HDD Cooler Four (4) Dampers : For reducing the HDD noise and vibration One (1) Ground Wire : For Grounding the HDD Spare Parts : A-Type Bolt, B-Type Bolt, Damper (One of Each) Mounting Hole Sticker : For indicating the drilling positions on the case User's Manual See the <Fig. Exploded View> on page 2 to identify the above components. 7. Before Installing 1) Use a small amount of force : if excessive force is used when installing, the product may warp or be deformed. Use one of the B-Type Bolts to link the ground wire's Y-terminal to the chassis. [Refer to arrow B] Note) Tighten the B-type bolts enough so that they are firm, but do not cause distortion of the dampers. B-Type Bolt B 10. Installing the HDD Cooler in the Case 1) Install the Dampers & the Ground Wire Install the 4 Dampers in the holes on the bottom side of the HDD. Insert the thread of one of the dampers through the ground wire's round terminal for the ground. [Refer to arrow C] Ground Wire Damper C 5 Attach the Mounting Hole Sticker to the case in which you wish to install the HDD Cooler and drill 4 holes with 4 drill. Power Supply Mounting Hole Sticker Power Supply B-Type Bolt Put the HDD Cooler on the frame of the case and firmly fasten with 4 B-Type Bolts. [. . . ] [Refer to arrow C] Ground Wire Damper C 5 Attach the Mounting Hole Sticker to the case in which you wish to install the HDD Cooler and drill 4 holes with 4 drill. Power Supply Mounting Hole Sticker Power Supply B-Type Bolt Put the HDD Cooler on the frame of the case and firmly fasten with 4 B-Type Bolts. Use one of the B-Type Bolts to link the ground wire's Y-terminal to the chassis. [. . . ]