User manual ZANKER 235 CC FS

[. . . ] · Before any cleaning or maintenance work is carried out, be sure to switch off and unplug the appliance. Care should be taken when moving it Ice lollies can cause frost burns if consumed straight from the appliance. Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. The appliance must not be located close to radiators or gas cookers. [. . . ] The materials used on this appliance marked by the symbol are recicable. Installation · During normal operation, the condenser and compressor at the back of the appliance heat up considerably. For safety reasons, minimum ventilation must be as shown in the relevant Figure. Attention: keep ventilation openings clear of obstruction. · There are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. Parts which heat up should not be exposed. Wherever possible the back of the product should be against a wall. If the appliance has been transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit. It · · CONTENTS Warnings . . 10 Use / Cleaning the interior - Operation - Temperature regulation - Fresh food refrigeration . Movable shelves - Positioning the door shelves . . 13 Hints / Hints for refrigeration / Maintenance / Periodic cleaning - Periods of no operation . . 14 Customer service and spare parts /Installation - Location - Rear spacers . . 15 Installation /Electrical connection - Changing the opening direction of the doors . . 16 12 USE Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. refrigerator depends on: · · · · room temperature; how often the door is opened; the quantity of food stored; location of appliance. A medium setting is generally the most suitable. Important If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. [. . . ] If there are water drops on the bottom of the cabinet, check that the defrost water drain · opening is not obstructed (see "Defrosting" section). If your appliance is still not working properly after making the above checks, contact the nearest service centre. To obtain fast service, it is essential that when you apply for it you specify the model and serial number of your appliance which can be found on the guarantee certificate or on the rating plate located inside the appliance, on the bottom left-hand side. INSTALLATION Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. For safety reasons, minimum ventilation must be as shown in Fig. Appliance positioned under overhanging kitchen wall units (see Fig. [. . . ]