User manual ZANKER AE 2050

[. . . ] It is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Important: if the supply cable is damaged, it must be replaced by a special cable available from your local Service Force Centre. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. [. . . ] Important Do not put carbonated liquids, (fizzy drinks etc. ), in the freezer compartment. Ice Iollies, if consumed immediately after removal from the freezer, can possibly result in a low temperature skin burn. Do not remove items from the freezer if your hands are damp/wet, as this could cause skin abrasions or "frost/freezer burns". Important In the event of a power cut do not open the door. The food in the freezer will not be affected if the power cut is short and if the freezer is full. Should the food begin to thaw, it must be consumed quickly and must not be re-frozen. Making ice cubes The appliance is provided with one or more plastic ice cube trays. Fill the tray(s) 3/4 full to give the ice space to expand and place them in one of the freezer compartment. To release the ice cubes simply give the tray a slight twist. Do not use sharp or metallic instruments to remove the trays from the freezer. Normal Operating Sounds · You may hear faint gurgling or bubbling sounds when the refrigerant is pumped through the coils or tubing at the rear, to the cooling plate/evaporator or to the fixed freezer shelves. When the compressor is on, the refrigerant is being pumped round, and you will hear a whirring sound or pulsating noise from the compressor. A thermostat controls the compressor, and you will hear a faint 'click' when the thermostat cuts in and out. · · 5 HINTS AND TIPS Food Storage To obtain the best performance from your freezer · · Do not store warm food or evaporating liquids. Chicken: Should also be cooked and refrozen as a fresh dish. · · · Energy Saving Advice · · Do not install the appliance close to sources of heat, such as a boiler or radiator. Locate the appliance in a cool well ventilated room and make sure that the air openings of the appliance are not obstructed. Freezing Calendar The symbols show different types of frozen goods. The numbers indicate storage times in months for the appropriate types of frozen goods. Whether the upper or lower value of the indicated storage time is valid depends on the quality of the foods and pre-treating before freezing. 6 MAINTENANCE AND CLEANING Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply. Defrosting When the frost has reached a thickness of up to 4mm it can be removed using the ice scraper provided with the appliance. 7 SOMETHING NOT WORKING If the appliance is not working correctly, please carry out the following checks before contacting your local Service Force Centre Symptom No power to the appliance Solution Check there is power at the socket. Check there is not a power cut by checking the household lights. Check the fuse has not blown. The temperature in the freezer is too high Check the thermostat control knob on the top panel is turned to the correct setting relative to ambient conditions. Check the ambient temperature is within the appliance's operating limits, please refer to the installation section in this instruction book. Relocate the appliance if necessary. The freezer door will not open The compressor runs continuously Has door just been opened?If so leave for a few minutes to allow the air pressure to equalise. Adjust the thermostat control knob to give correct temperature control. [. . . ] Adjust the level of the appliance by screwing out the adjustable foot, or feet, at the bottom of the cabinet using your fingers or a tool (see figure). B 10 mm NP006 D200 Rear spacers In the appliance, there are two spacers which must be fitted in the two top corners. Slacken the screws and insert the spacer under the screw head, then re-tighten the screws. 12 Electrical connections Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. [. . . ]