User manual ZANKER ICO30B

[. . . ] This information has been provided in the interest of your safety. You MUST read it carefully before installing or using the appliance. Installation q q Check your dishwasher for any transport damage. If your dishwasher is damaged, you should contact your supplier. For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way. [. . . ] Do not worry if water over flows from the unit when filling with salt, this is quite normal. Adjusting the dose According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (position 1 minimum dosage, position 6 maximum dosage). Increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce it if there are sticky whitish streaks on the dishes. BR09 Top up the rinse aid when the indicator light on the control panel illuminates. 25 If you are using dishwasher detergent that includes the rinse aid function, this must be placed in the detergent compartment. In this case the inflow of the rinse aid must be deactivated, in order to avoid a double dosage . Deactivation/activation of the inflow of rinse aid (The dishwasher must be switched off) When the inflow of rinse aid has been deactivated, also the rinse aid indicator light on the control panel is automatically deactivated. Press the On/Off push button, all indicator lights of the programme push buttons will illuminate (setting mode). Press simultaneously function push buttons 2 and 3, the indicator lights of the function push buttons 1, 2 and 3 start flashing. Press the function push button 2, the indicator lights of function push buttons 1 and 3 turn off while the indicator light of the push button 2 goes on flashing, at the same time the "end of programme" indicator light illuminates indicating that the inflow of rinse is active. To deactivate the inflow of rinse aid, press again the function push button 2, the "end of programme" indicator light turns off, indicating that the inflow of rinse aid has been deactivated. To memorise the operation, switch off the dishwasher by pressing the On/Off push button or wait about 60 seconds after which the dishwasher will automatically return to setting mode. 26 In daily use q q q q Check if it's necessary to refill with special salt or rinse aid Load cutlery and dishes into the dishwasher. Select a wash programme suitable for the cutlery and dishes. Start the wash programme. Loading cutlery and dishes Sponges, household cloths and any object that can absorb water may not be washed in the dishwasher. q q Before loading the dishes, you should: - Remove large left-overs. Light items (plastic bowls etc. ) must be loaded in the upper basket and arranged so they do not move. Adjusting the height of the upper basket If washing very large plates you can load them in the lower basket after moving the upper basket to the higher position. Maximum height of the dishes in upper basket lower basket With upper basket raised With upper basket lowered 20 cm 24 cm 31 cm 27 cm To move to the higher position proceed as follows: 1. Move the front runner stops (A) of the upper basket outwards and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. When the basket is in the higher position you will not be able to use the cup rack(s). US73 In case that plates are loaded in the upper basket: load them starting from the rear positions of the basket; tilting them slightly forwards and avoiding the front positions near the door. US71 RC01 After loading your machine always close the door, as an open door can be a hazard. Before closing the door, ensure that the spray arms can rotate freely. 28 Use of detergent Only use detergents specifically designed for use in dishwashers. Using no more then the correct amount of detergent contributes to reducing pollution. Prior to the start of a wash programme. The detergent is released during the washing phase. Please observe the manufacturer's dosing and storage recommendations as stated on the detergent packaging. Fill with detergent 1. If the lid is closed: press release button (1). Fill the detergent dispenser (2) with detergent. The marking indicates the dosing levels: 20 = approximately 20 g of detergent 30 = approximately 30 g of detergent 3. All programmes with prewash need a little amount of detergent (5/10 g) to be added in the adjacent chamber (3). DE19 DE22 4. [. . . ] - 3 intermittent audible signals - 3 flashes of the "end of programme" indicator light Possible cause The water tap is blocked or furred with limescale. The filter (where present) in the threaded hose fitting at the water inlet valve is blocked. The water inlet hose has not been correctly laid or it is bent or squashed. Solutions Clean the water tap. Clean the filter in the threaded hose fitting. [. . . ]