User manual ZANKER KE9000

[. . . ] 14 Cleaning the exterior and the control panel. 15 Emptying the condensed water container . 35 2 IMPORTANT SAFETY INSTRUCTIONS , WARNING - To reduce the risk of Do not repair or replace any part of the appliance or attempt any servicing unless specifically recommended in these operating instructions. Repairs to electrical appliances should only be performed by qualified personnel. [. . . ] Should the container be full when the tumble dryer is started, or if it becomes full during normal operation: ­ The "Container" indicator will light. ^ Pull out the container slightly to the right with both hands. ^ Hold the cap open while emptying the container. ^ When the container is empty, push it back into its opening until it clicks into place. Do not drink the condensed water! 16 Dryer care Cleaning the condenser shock, disconnect the dryer from the power supply by shutting off the power main, tripping the circuit breaker or unplugging the power cord before performing maintenance. Detergent residues, hair and lint in the drying air can penetrate filters and clog the condenser. Particles from the cool air sucked in from the install location can cause blockages. ^ Check the condenser at least twice a year. ^ Open the access panel, located on the lower left corner of the machine, using the yellow tool supplied with the machine. Removing the condenser ^ Open the door. , To reduce the risk of electric ^ Remove the panel up and out of the condenser access area. ^ Turn the condenser door lock down and remove the door. 17 Dryer care Checking the condenser ^ Hold the condenser against the light. ^ Turn the condenser lock up. ^ Look through the front and left side (as illustrated above) of the condenser to check for lint. For items to be left damp for ironing. Note The "Extra Dry" program should not be selected for jersey materials. Items may shrink. More Dry Normal Less Dry Hand Iron Rotary Iron If items are still damp, dry again using "More Dry". If fabrics are too damp, dry again using "Less Dry". For items to be ironed with a rotary iron. For items that do not require ironing, e. g. For items which require ironing. To prevent moisture loss, roll up the laundry until ready to iron. Wrinkle-free Available drying options Turbo, Gentle, Anti-crease More Dry Normal Less Dry Reduce load size for fabrics that wrinkle easily. Special Programs Available drying options: Anti-crease only available in Fluff, Sturdy Woolens Delicate items which allow machine drying. Program for reducing creasing in delicate items. Individual items to be freshened and fluffed with cool air. Individual items or very small loads, e. g. Take items out immediately after the end of the program while still slightly damp. Allow items to air dry. Smooth Sturdy Fluff - TIMED CYCLES 20 min 30 min Available drying options Gentle, Anti-crease - Frequently asked questions What if the dryer will not run?Possible fault The "Start/Stop" button was not pressed. The circuit breaker tripped or the dryer is unplugged. [. . . ] Reinstallation of the machine lid When reinstalling the appliance lid, check the firm fit of the cover at the rear bracket for a safe transport of the dryer. 31 Installation Installation tips An airflow gap of 3/8" (10 mm) must be provided between the machine and the floor. This airflow gap must not be blocked by a toekick or thick piled carpets. Do not install the dryer next to a refrigerator. The warm air exhausting from the dryer will affect the thermostat of the refrigerator, causing it to run continuously. Level the dryer ^ The dryer must be level to ensure safe and proper operation. ^ The machine can be leveled by turning the legs clockwise or counterclockwise as necessary. 32 Installation Installing the decor panel The door can be fitted with a customized door panel (optional accessory) to match the adjacent cabinets. [. . . ]