User manual ZANKER NOVELLA90/2MW

[. . . ] The dispenser, which is positioned inside the door, holds about 110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing programmes, depending upon the dosage setting. Rinse aid can be added in one of two ways: q To fill: 1. Open the door, remove the lower basket and unscrew the cap of the salt container by turning it anticlockwise. Pour 1 litre of water inside the container (this is necessary only before filling with salt for the first time). Using the funnel provided, pour in the salt until the container is full. [. . . ] Switch the water hardness setting to the highest possible position and run a normal washing programme without a load. Readjust the water hardness setting again according to the hardness of the water in your area. q DE19 DE22 4. Close the lid and press until it locks in place. Concentrated detergent Fill with detergent (Detergent dispenser type B) 1. Open the dispenser by pulling the catch (A). Fill the detergent dispenser with detergent. The marking indicates the dosing levels: Min = approximately 15 g of detergent Max = approximately 30 g of detergent 3. Close the lid and press until it locks in place. Based on their chemical composition, dishwasher detergents can be split into two basic types: - conventional, alkaline detergents with caustic components. - low alkaline concentrated detergents with natural enzymes. The use of 50°C washing programmes in conjunction with concentrated detergents reduces pollution and is good for your dishes; these wash programmes are specially matched to the dirt-dissolving properties of the enzymes in the concentrated detergent. For this reason 50°C wash programmes in which concentrated detergents are used can achieve the same results that can otherwise only be achieved using 65°C programmes. Detergent tablets Detergent tablets of different brands dissolve at different speeds. Turn the handle about 1/4 a turn anticlockwise and remove. Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Moving the machine If you have to move the machine (moving house etc. . . . ): 1. Remove the water inlet and discharge hoses. Pull the machine out together with the hoses. Avoid over tilting the machine during transportation. MA36 4. Take hold of the coarse/fine filter (A/B) by the handle with the hole and remove from the microfilter (C). Clean all filters thoroughly under running water. Remove the flat filter (D) from the base of the washing compartment and clean both faces thoroughly. MA31 7. Put the flat filter back in the base of the washing compartment. 38 What to do, when. . . Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions given here, without calling out an engineer. . . . there are problems when operating the dishwasher The dishwasher will not start or stops during operation. All push buttons are inoperative except for the On/Off push button. Press the On/Off push button to switch the dishwasher off and carry out the following suggested corrective actions. Malfunction The machine does not fill with water. Possible cause The water tap is blocked or furred with limescale. [. . . ] Contact the detergent manufacturer's consumer care line. 39 If after all these checks, the problem persists, contact your local consumer services department, quoting the model (Mod. ), product number (PNC) and serial number (S. N. ). This information can be found on the rating plate located on the right hand side of the dishwasher door (see picture). So that you always have these numbers at hand, we recommend you to make a note of them here: Mod. [. . . ]