User manual ZANKER TC7102W

[. . . ] 125992062. qxp 2004-05-24 09:03 Page 1 TUMBLE DRYER TC 7102 W TC 7102 S DUAL CONDENSER DRYER TEMPERATURE TC 7102 W COTTON IRON DRY Spun at rpm SYNTHETICS STORE DRY 800 / 900 1000 / 1200 STORE DRY Spun at rpm LOW TEMP. START 800 / 900 1000 / 1200 650 kg 6 kg 2. 5 95' - 115' 85' - 105' 45' - 60' 40' - 55' 120' - 140' 60' - 75' 95' - 115' 55' - 70' kg 2. 5 kg 1 65' - 75' 30' - 40' 6 AUTOREVERSE XTRACAPACITY DRYING TIME Unpacking: see page 14 125992062 INSTRUCTION BOOKLET GB 125992062. qxp 2004-05-24 09:03 Page 2 Important Safety Information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety. You MUST read them carefully before installing or using the appliance. Installation · This appliance is heavy. [. . . ] · DO NOT load dripping wet laundry into the dryer. The filters collect all the fluff which accumulates during drying and they must therefore be cleaned at the end of each programme, before removing the laundry, with a damp cloth. Clean the air condenser periodically, 3 or 4 times a year depending on how frequently the dryer is used. The condenser is situated at the lower part of the cabinet behind a small door. To open the door, push the catch as per picture. P1177 kg 5 kg 2, 5 70' - 90' 35' - 50' 800 / 900 1000 / 1200 65' - 85' 30' - 45' 80' - 100' 70' 55' - 800 / 900 1000 / 1200 75' - 95' 50' - 65' kg 1 kg 2, 5 50' - 60' 30' - 35' 650 E RS VE RE TO AU To pull out the condenser, first turn the two red stops inwards as shown and then remove the condenser unit holding it at the handle. P1110 P1151 The filter in the inner door must be removed for cleaning. Do not be alarmed by the amount of fluff. It is not due to excessive wear caused by the dryer. All fabric looses fluff when drying but it goes un-noticed in the air. In a tumble dryer it simply collects in the filter. P1159 P1155 It is quite normal to find droplets of water on top of or at the front of the condenser unit. This is not a fault with the appliance. 9 125992062. qxp 2004-05-24 09:03 Page 10 Clean it with a brush and rinse it under the shower if necessary. · P0639 P1202 Also clean the outside, removing all fluff. Clean the rubber seal round the condenser cabinet and in the inner part of the small door with a damp cloth. Do not use pointed objects or utensils to clean the spaces between the plates, as this could damage the condenser and make it permeable. Re-fit the condenser, turn the red stops upwards and close the door. Do not use this appliance if the condenser has not been fitted. The reservoir must be re-inserted correctly. After inserting the reservoir the programme will continue after about 20 seconds. Handy tip: The condensed water may be used in a steam iron or to top up a battery, etc. through a coffee filter). Cleaning the air intake grille Using a vacuum cleaner remove the fluff from the air intake grille at the back of the appliance. Emptying the water reservoir Water extracted from the laundry condenses inside the machine and is collected in a reservoir. The reservoir must be emptied after each drying cycle to ensure efficient operation when the machine is next used. If this is not done a safety device trips: pilot light on the control panel comes on and the programme stops, leaving the laundry damp. The reservoir can be emptied even in the middle of a programme. Proceed as follows: · Open the small door at the lower part of the cabinet · Turn the yellow stop upwards · Pull out the reservoir · Open the small cover and let water flow down · Close the small cover and re-insert correctly the reservoir · Push it until it clicks and turn the yellow stop downwards to lock firmly it · Close the small door and press the START/PAUSE button again to allow the programme to continue. P1162 10 125992062. qxp 2004-05-24 09:03 Page 11 Something Not Working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. IMPORTANT: if you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom The tumble dryer does not start Possible causes · The door(s) has(have) not been closed. [. . . ] To keep vibration and noise to a minimum when the dryer is in use, it should be placed on a firm, level surface. Once in its permanent operating position, check that the dryer is absolutely level with the aid of a spirit level. If it is not, raise or lower the feet until it is. Do not restrict the floor clearance through deeppile carpets, strips of wood or similar. [. . . ]