User manual ZANKER ZANKER4635

[. . . ] It is dangerous to alter the specifications or attempt to modify this product in any way. All packing and transit bolts must be removed before use. Serious damage can occur to the product and to property if this is not adhered to. Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person. [. . . ] Water filling: 30°-30°-40° programmes: cold water filling 50°-60° programmes: hot and cold filling 95° programme: hot water filling The programme times are intended as a guide only. The actual time will vary depending on incoming water temperature and pressure. · Some programmes when selected may start with a short drain. This is quite normal and not a fault with the appliance. When a programme is selected, the selector dial will advance to the water filling position. Programme B is selected, there is a short drain. The appliance takes in water and the selector will appear to move to the C position. The appliance will have memorised the programme selected, in this case B, and will run the correct programme even though the selector dial appears to be at position C. · We recommend you not to switch the appliance off and on during its operation. This would modify the memorised programme in progress with unsatisfactory washing results. 14 Washing Programmes Programmes for synthetics, mixed fabrics, delicates and wool Wash programme/ Washing symbol Degree of soil and type of laundry Synthetic or mixed fabrics, underwear, coloured garments, non-shrink shirts, blouses. Remove the drawer by pressing the catch downwards and by pulling it out. Flush it out under a tap, to remove any traces of accumulated powder. To aid cleaning, the top part of the additive compartment should be removed. P1114 · Place a container close to the pump to collect any spillage. · Pull out the emergency emptying hose, place it in the 16 container and remove its cap. · When no more water comes out, unscrew the pump cover and remove it. Always keep a rag nearby to dry up spillage of water when removing the cover. P1115 · Remove any objects from the pump impeller by rotating it. · Put the cap back on the emergency emptying hose and place the latter back in its seat. P1117 · Screw the pump cover fully in. · Close the pump door. Warning When the appliance is in use and depending on the programme selected there can be hot water in the pump circuit. Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When replacing the pump cover, after a cleaning inspection, ensure it is securely retightened so as to stop leaks and young children being able to remove it. Cleaning the water inlet filters If your water is very hard or contains traces of lime deposit, the water inlet filters may become clogged. It is therefore a good idea to clean it from time to time. 17 Something Not Working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Force Centre, please carry out the checks listed below. [. . . ] (23. 6") 24 Levelling Level the washing machine by loosening or tightening the feet. Once in the right position fix the feet by pushing the nuts against the base of the case. Accurate levelling prevents vibration, noise and displacement of the machine during operation. After levelling the machine, secure the feet by tightening the ring nuts with the aid of a screwdriver. [. . . ]