User manual ZANKER ZKD4050G

[. . . ] You MUST read it carefully before installing or using the appliance. Installation q q Check your dishwasher for any transport damage. If your dishwasher is damaged, you should contact your supplier. For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way. Any electrical and plumbing work required to install this appliance should be carried out by a qualified and competent person. [. . . ] Never fill the rinse aid dispenser with any other substances (e. g. dishwasher cleaning agent, liquid detergent). This would damage the appliance. The salt container will require topping up periodically. You are reminded of this by the salt indicator light on the control panel which comes on when the salt has finished. The salt indicator light on the control panel can remain illuminated for 2-6 hours after the salt has been replenished, assuming the dishwasher remains switched on. If you are using salts that take longer to dissolve then this can take longer. The function of the machine is not affected. Do not worry if water over flows from the unit when filling with salt, this is quite normal. Adjusting the dose According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (position 1 minimum dosage, position 6 maximum dosage). Increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce it if there are sticky whitish streaks on the dishes or a bluish film on glassware or knife blades. Top up the rinse aid when the indicator (B) becomes clear. 26 In daily use q Check if it's necessary to refill with dishwasher salt or rinse aid Load cutlery and dishes into the dishwasher. Select a wash programme suitable for the cutlery and dishes. Light items (plastic bowls etc. ) must be loaded in the upper basket and arranged so they do not move. Use of detergent Only use detergents specifically designed for use in dishwashers. Using no more than the correct amount of detergent contributes to reducing pollution. Please observe the manufacturer's dosing and storage recommendations as stated on the detergent packaging. Fill with detergent 1. If the lid is closed: press release button (1). Fill the detergent dispenser (2) with detergent. The marking indicates the dosing levels: 20 = approximately 20 g of detergent 30 = approximately 30 g of detergent Before closing the door, ensure that the spray arms can rotate freely. Adjusting the height of the upper basket If washing very large plates you can load them in the lower basket after moving the upper basket to the higher position. Maximum height of the dishes in upper basket lower basket 3. All programmes with prewash need an additional detergent dose (5/10 g) that must be placed in the prewash detergent chamber (3). This detergent will take effect during the prewash phase. Close the lid and press until it locks in place. With upper basket raised With upper basket lowered 20 cm 24 cm 31 cm 27 cm To move to the higher position proceed as follows: 1. Move the front runner stops (A) of the upper basket outwards and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. [. . . ] For other combinations of fault codes not described in the above chart, please contact your local Service Force Centre. . . . there are problems when operating the dishwasher Malfunction Possible cause The dishwasher door has not been properly closed. The programme does not start The fuse has blown in the household fuse box. For dishwasher models with delay start option: Delay start has been selected. There is a whistling noise during washing The whistling is not a cause for concern. [. . . ]