User manual ZANKER ZKDW24

[. . . ] Afwasautomaat - Lave-vaisselle - Geschirrspüler - Dishwasher NL Gebruiksaanwijzing (deel 1) bladzijde 2 F Notice d'utilisation (partie 1) page 11 D Bedienungsanleitung (Teil 1) Seite 23 GB Instruction book (part 1) page 33 Only use salt specifically designed for use in dishwashers. All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener. Only fill with salt just before starting one of the washing programmes (except the Rinse and Hold programme). This will prevent any grains of salt or salty water, which may have been spilt, remaining on the bottom of the machine for any period of time, which may cause corrosion. Rinse aid Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying. [. . . ] Therefore please use normal programmes with prewash when using detergent tablets. DE17 DE02 4. All programmes with prewash need an additional detergent dose (5 g) that must be placed over the lid of the dispenser. This detergent will take effect during the prewash phase. 37 Maintenance and cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run a 65°C wash programme without dishes using detergent. Place the coarse/fine filter in the microfilter and press together. Put the filter combination in place and lock by turning the handle clockwise to the stop. During this process ensure that the flat filter does not protrude above the base of the washing compartment. Under no circumstances may the dishwasher be used without filters. To ensure a correct working of the dishwasher, NEVER try to remove the upper spray arm. If residues of soil have clogged the holes in the upper spray arm, remove them with a toothpick. MA33 Cleaning the filters The filters in the base of the washing compartment are to a large extent self-cleaning. Nevertheless the filters should be checked and cleaned from time to time. Dirty filters will degrade the washing result. The dishwasher filter system comprises a coarse/fine filter (A/B), a microfilter (C) and a flat filter (D). Some dishwasher models filter system comprises only a coarse filter (A), a microfilter (C) and a flat filter (D). Unlock the filter system using the handle on the microfilter, and remove. Prolonged periods of non-operation If you are not using the machine for any period of time you are advised to: 1. Unplug the appliance and then turn off the water. Leave the door ajar to prevent the formation of any unpleasant smells. Leave the inside of the machine clean. Frost precautions MA35 MA32 3. Turn the handle about 1/4 a turn anticlockwise and remove. Avoid placing the machine in a location where the temperature is below 0°C. [. . . ] The dishwasher features fill and drain hoses which can be turned either to the left or the right to suit the installation. The dishwasher is fitted with safety devices that prevent the wash water returning into the drinking water system and comply with the applicable plumbing regulations. Do not use, for connection, old hoses which have been used in another appliance. If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. 3. [. . . ]