User manual ZANKER ZKS5550I

[. . . ] Geschirrspüler Dishwasher ZKS 5550 I Bedienungsanleitung Instruction book Contents For the user Important safety information Description of the appliance The control panel Before use Setting the water softener Rinse aid Using your appliance Loading your appliance Adjusting the height of the upper basket Use of detergent Hints and tips Washing programmes Operating sequence Maintenance and cleaning Internal cleaning Cleaning the central filters Cleaning the large filter External cleaning Prolonged periods of non-operation Frost precautions Moving the machine Something not working Protection against flooding Service and spare parts Hints for test centres Technical specifications 26 27 27 28 28 30 31 31 32 33 34 35 36 37 37 37 37 38 38 38 38 39 40 40 41 41 For the installer Installation instructions Water supply connections Water outlet hose connection Electrical connection Building-in 42 42 43 43 44 Guide to use the instruction book The following symbols will be found in the text to guide you throughout the instructions: Safety instructions 1. Step by step Hints and tips Environmental information 25 IND04en Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of your safety. [. . . ] Check the filters Ensure they are clean and properly positioned (see "Maintenance and cleaning"). 7. Start the programme Depress the On/Off push button and close the door, the machine will start. 2. Check that there is rinse aid and salt Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. Slide the baskets back into the machine. 8. At the end of the washing programme At the end of the programme the dishwasher will automatically stop. 3. 9. Switch off the dishwasher Open the door and switch off the dishwasher by pressing the On/Off push button. 4. Ensure that the spray arms can rotate freely. Measure out detergent Add the required amount of detergent into the dispenser according to the dosage istructions from the manufacturer of your brand. Close the detergent dispenser lid. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. In general it is not advisable to open the door while the machine is working;if the door is opened however, a safety device ensures that the machine stops. 5. 6. Set the programme The selection of the programme occurs with the door partially opened. Turn the programme selector dial clockwise until the letter of the programme you wish to select corresponds with the programme marker on the control panel. If necessary select the temperature of the main wash according to the instructions in the "Washing programmes" chart (see "Required push buttons"). Important!Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape. 36 SEQ23en Maintenance and cleaning Internal cleaning Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run a 65°C wash without dishes using detergent. Cleaning the central filters (After each wash) Inspect the central filters (B) and (C) and remove any scraps of food with a brush, under running water. Filters (B) and (C) are both removed by lifting up the outer one (B) (pulling the central funnel upwards); the smaller filter (C) can be removed by pressing the two tongues (D). Once cleaned, refit the filters by pressing them down until they click into place. MA02 D C B Cleaning the large filter (Once a month) Clean the large filter (A) on both sides under running water, using a brush. To take it out, remove the spray arm by pressing the two tongues (E), turn the ring (F) anticlockwise and then slide the whole part out. Refit the filter following the above instructions in reverse order. MA08 E A The dishwasher must not be used without filters. Incorrect repositioning and fitting of the filters will produce poor washing results. Cleaning the filters is vital to ensure correct operation of the machine. F MA03 37 MAN08en External cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Prolonged periods of non-operation If you are not using the machine for any period of time you are advised to: 1. Unplug the appliance and then turn off the water. Leave the door ajar to prevent the formation of any unpleasant smells. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. [. . . ] No further openings for venting of the dishwasher are required, but only to let the water fill and drain hose and power supply cable pass through. 818 ÷ 878 44 596 5 57 x ma 5 55 x ma The recess height may be anywhere between 820 and 880 mm from the floor as the dishwasher incorporates adjustable feet (max 60 mm). A distance of 2 mm should be allowed between the top of the dishwasher and the counter top. - 450 + II66 Adjusting the height of the appliance To adjust the height proceed as follows: 1. The rear foot is adjusted by turning the screw in the middle of the front kick plate to the left or right. Pads are supplied for the feet to make sliding the appliance in and out of the recess easier. [. . . ]