User manual ZANUSSI CWH6065B

[. . . ] If other types of flue or appliances are fitted ensure that there is an adequate supply of air to the room. The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose. Do not install above a cooker with a high level grill. · Child Safety This appliance is designed to be operated by adults. [. . . ] Once the slot with the metal bar is released, the metal grease filter can be removed. When replacing the filter panels ensure that the securing bolts face downwards. 3. 4. The metal grease filters should be washed, by hand, in mild soapy water or in a dishwasher. Allow to dry completely before replacing. 6 Charcoal Filter In the recirculation mode the charcoal filter absorbs smells and odours. The charcoal filter cannot be cleaned, we recommend it should be replaced approximately every three months or more often if the hood is used for more than three hours per day. To Remove/Replace the Charcoal Filter 1. Unscrew the two screws located on each side of the charcoal filter. This appliance can be a fire hazard if the grease and charcoal filters are not replaced as recommended. To Change the Fluorescent Tube: 1. The glass strip is kept in position by retaining lugs (Z). Move the glass strip foward the control box until the opposite end is free (arrow 1). Pull the glass strip slightly down (arrow 2) and then move it back toward the opposite direction (arrow 3) until the glass strip can be removed. The tube can removed by rotating it 90°. Replace with a new tube of the same type and then refit the plastic cover by following instructions 1 and 2 in reverse. 2. 3. · The product is installed and used in accordance with our instructions and is only used domestically, i. e. Before you move please contact your nearest Customer Care Centre, listed below, to give them details of your new home. They will then ensure that the local Service Organisation is aware of your move and able to look after you and your appliances. France Germany Italy Sweden UK Senlis Nurnberg Pordenone Stockholm Newbury +33 (0)3 44 62 29 99 +49 (0)911 323 2600 +39 (0)1678 47053 +46 (0)8 738 79 50 +44 (0)1635 521 313 9 INSTALLATION INSTRUCTIONS It is dangerous to alter the specifications or attempt to modify this product in any way. Technical Information DIMENSIONS HEIGHT CANOPY: HEIGHT CHIMNEY - UPPER SECTION: HEIGHT CHIMNEY - LOWER SECTION: WIDTH CANOPY: DEPTH: Voltage (50Hz) 24 cm 40 cm 36 cm 60-90 cm 49 cm 220-240 V 155 W 140 W 15 W 650 m3/hr 62 db ELECTRICAL SUPPLY: POWER CONSUMPTION: FAN MOTOR: LAMP: MAX AIRFLOW: MAX NOISE LEVEL: SUITABLE FOR INSTALLATION ABOVE: OVER ELECTRIC HOB: OVER GAS HOB: SLOT-IN GAS COOKER: SLOT-IN ELECTRIC COOKER: 7KW (max) 10KW (max) 13. 5KW (max) 12. 4KW (max) Note: CE Marking certifies that this appliance complies with the requirements laid down in EEC directive 89:336. (Electromagnetic compatibility) and subsequent modifications and Low Voltage directive 72/23/E. ELECTRICAL CONNECTIONS This appliance must be earthed Electrical Requirements Any permanent electrical installation must comply with the latest I. E. E. Regulations and local Electricity Board regulations. For your own safety this should be undertaken by a qualified electrician e. g. your local Electricity Board, or a contractor who is on the roll of the National Inspection Council for Electrical Installation Contracting (NICEIC). This appliance is fitted with a 3 core mains cable and must be permanently connected to the electricity supply via a double-pole switch having 3mm minimum contact gap on each pole. A Switched Fuse Connection Unit to BS1363 Part 4, fitted with a 3 Amp fuse, is a recommended mains supply connection accessory to ensure compliance with the Safety Requirements applicable to fixed wiring instructions. This appliance conforms to BS 800: 1988 and EEC Directive No. A clearance height of 685mm (27") is required when installed above a slot-in electric cooker, or 787mm (30 1/2 ") when installed above a slot-in gas cooker. [. . . ] Remove the two screws on top of the canopy and secure the spigot, fit the spigot (A) on the rectangular air outlet on the top of the canopy using the two screws. Connect the ducting to the ducting spigot (A) using suitable clamps (not supplied). The charcoal filter is not required when installed for extraction. (To remove see maintenance and cleaning section). 2. 3. Recirculation The charcoal filter must be fitted for recirculation. [. . . ]