User manual ZANUSSI DA4142

[. . . ] DISHWASHER DA 4142 152969 88/0 Instruction Book UK Description of the appliance 1. Water hardness adjustment Upper basket stop Upper spray arm Salt container Detergent dispenser Control panel Rinse aid dispenser Filters Lower spray arm 11 1 2 3 10 10. Worktop 9 4 8 5 7 6 IN112 The control panel 2 In daily use q q q q Check if it's necessary to refill with special salt or rinse aid Load cutlery and dishes into the dishwasher. Select a wash programme suitable for the cutlery and dishes. [. . . ] Replace the cap making sure that there is no trace of salt on the screw thread or on the gasket. The salt container will require topping up periodically. According to the model, an indicator reminds you when filling with salt: A) The salt cap has a refill indicator window in the centre. A green float is clearly visible when there is salt inside the container, and almost disappears when the salt has finished reminding you to add salt. B) A salt indicator light on the control panel will come on when the salt has finished. SR11 Only for dishwasher models with salt refill indicator light: if the water softener has been adjusted on level 1 without use of salt, the salt refill indicator light on the control panel will always remain illuminated when the machine is switched on. LE SA UT ZO LT SA LZ SA L SE To adjust the water softener, follow the instructions given in the chart Water hardness French Clarke Level degrees degrees (°TH) PPM (parts per million) Use of salt Adjustment Water on the machine softener adjustment SR14 A* B 1 2 3 4 5 0-8 9 - 20 0-6 7 - 14 0 - 80 81 - 200 NO YES + + NO NO NO YES YES 1 1 1 2 2 21 - 40 15 - 28 201 - 400 YES 41 - 70 29 - 49 401 - 700 YES 71 - 90 50 - 63 701 - 900 YES * If your appliance is type A and adjustment is necessary, YES in the water softener chart indicates that the membrane must be pierced as shown. Water softener adjustment AA01 The salt indicator light on the control panel can remain illuminated for 2-6 hours after the salt has been replenished, assuming the dishwasher remains switched on. If you are using salts that take longer to dissolve then this can take longer. The function of the machine is not affected. 2 Rinse aid Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying. The dispenser, which is positioned inside the door, holds about 110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing programmes, depending upon the dosage setting. Use of detergent Only use detergents specifically designed for use in dishwashers. We recommend the use of Finish detergents which are available in the following options: Finish Double Action Tablets. Each tablet has the exact amount of detergent required, simply place in the dispenser. Finish Powder recommended for every day use. Finish Liquid Gel ideal for every day use. As the gel is extra gentle is it recommended for fine bone china. Filling with rinse aid 1. Open the container by turning the lid (A) anticlockwise. Add the rinse aid until the container is completely full. The indicator (B) will be completely dark. If using powder detergents proceed as follows: 1. Open the dispenser lid by pulling the catch (D). Add the detergent according to the recommended quantity given in the "Washing programmes" chart (see "Instruction Book - Part 2"). As all detergents are not the same, you should also consult the instructions on the packet. If the programme has a prewash add a little amount of detergent over the lid of the dispenser. Follow the recommended quantity given in the "Washing programmes" chart (see "Instruction Book - Part 2"). BR01 BR03 3. [. . . ] If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. This will prevent deposits of sand or rust clogging the inlet hose. Attention!Our appliances are supplied with a with a security device to protect against the return of dirty water back into the machine. If the spigot of your sink has a "no return valve" incorporated this can prevent the correct draining of your dishwasher. [. . . ]