User manual ZANUSSI DA4342

[. . . ] DISHWASHER DA 4342 152977 35/2 INSTRUCTION BOOK UK Description of the appliance 1. Water hardness adjustment Levelling spacers Upper basket stop Upper spray arm Salt container Detergent dispenser Control panel Rinse aid dispenser Filters 10. Worktop IN115 The control panel 1. Salt refilling indicator light Illuminates when the salt has run out, to remind you to refill the salt container. [. . . ] Pour 1 litre of water inside the container (this is necessary only before filling with salt for the first time). SR11 B) A salt indicator light on the control panel will come on when the salt has finished. SR17 3. Using the funnel provided, pour in the salt until the container is full. The salt indicator light on the control panel can remain illuminated for 2-6 hours after the salt has been replenished, assuming the dishwasher remains switched on. If you are using salts that take longer to dissolve then this can take longer. The function of the machine is not affected. . Do not worry if water over flows from the unit when filling with salt, this is quite normal. SR18 4. Remove any trace of salt on the screw thread or on the gasket. SR19 5. Screw on the cap tightly. 4 Rinse aid Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying. The dispenser, which is positioned inside the door, holds about 110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing programmes, depending upon the dosage setting. Filling with rinse aid 1. Open the container by turning the lid (A) anticlockwise. Add the rinse aid until the container is completely full. The indicator (B) will be completely dark. Top up the rinse aid when the indicator (B) becomes clear. A BR01 Only for dishwasher models with rinse aid indicator light: Top up with rinse aid when the rinse aid indicator light on the control panel illuminates. Ensure that the lid is closed after every refill. Do not put liquid detergent in the rinse aid compartment. Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash. B m a x 6543 21 BR03 Adjusting the dose According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (C) (position 1 minimum dosage, position 6 maximum dosage). Increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce it if there are sticky whitish streaks on the dishes. m a x C 6543 21 BR02 5 Use of detergent Only use detergents specifically designed for use in dishwashers. We recommend the use of Finish detergents which are available in the following options: Finish Double Action Tablets. Each tablet has the exact amount of detergent required, simply place in the dispenser. Finish Powder recommended for every day use. Finish Liquid Gel ideal for every day use. As the gel is extra gentle is it recommended for fine bone china. Min = 15 g Max = 30 g D If using powder detergents proceed as follows: 1. Open the dispenser lid by pulling the catch (D). [. . . ] Avoid bends or kinks in the hose which could prevent or slow down the water supply. If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. This will prevent deposits of sand or rust clogging the inlet hose. 12 Water outlet hose connection The end of the drain hose can be connected in the following ways: 1. To the sink outlet spigot, securing it if necessary with a clip. [. . . ]