User manual ZANUSSI DA6153

[. . . ] DISHWASHER DA 6153 152968 28/1 Instruction Book UK Description of the appliance 1. Upper basket stop Water hardness switch Salt container Detergent dispenser (type A / type B) Control panel Rating plate Rinse aid dispenser (type A / type B) Filters Lower spray arm 10. Worktop IN148 The control panel 2 In daily use q q q q Check if it's necessary to refill with special salt or rinse aid Load cutlery and dishes into the dishwasher. Select a wash programme suitable for the cutlery and dishes. [. . . ] Open the container by pressing the release button (A). Fill with rinse aid exactly up to the level indicator marked "max". To fill: 1. Open the door, remove the lower basket and unscrew the cap of the salt container by turning it anticlockwise. Pour 1 litre of water inside the container (this is necessary only before filling with salt for the first time). Using the funnel provided, pour in the salt until the container is full. Replace the cap making sure that there is no trace of salt on the screw thread or on the gasket. Screw on the cap tightly turning it clockwise until it stops with a click. LE SA UT ZO LT SA LZ SA L SE BR07 BR14 Ensure that the lid is closed after every refill. SR14 Adjusting the dose According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (position 1 minimum dosage, position 6 maximum dosage). Increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce it if there are sticky whitish streaks on the dishes. BR09 The salt container will require topping up periodically. According to the model of dishwasher, you are reminded of this by: A) The salt cap has a refill indicator window in the centre. A green float is clearly visible when there is salt inside the container and almost disappears when the salt has finished reminding you to add salt. Filling with rinse aid SR22 (Rinse aid dispenser type B) 1. Open the container by turning the lid (A) anticlockwise. Fill with rinse aid exactly up to the level indicator marked "max". B) A salt indicator light on the control panel will come on when the salt has finished. The salt indicator light on the control panel can remain illuminated for 2-6 hours after the salt has been replenished, assuming the dishwasher remains switched on. If you are using salts that take longer to dissolve then this can take longer. The function of the machine is not affected. Do not worry if water over flows from the unit when filling with salt, this is quite normal. BR01 BR13 Ensure the lid is closed after every refill. 4 Adjusting the dose According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (C) (position 1 minimum dosage, position 6 maximum dosage). Increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce it if there are sticky whitish streaks on the dishes. Use of detergent Only use detergents specifically designed for use in dishwashers. We recommend the use of Finish detergents. Using no more then the correct amount of detergent contributes to reducing pollution. [. . . ] Do not use, for connection, old hoses which have been used in another appliance. The dishwasher is fitted with safety devices that prevent the wash water returning into the drinking water system and comply with the applicable plumbing regulations. 3. To a stand pipe provided with vent-hole, minimum internal diameter 4 cm. The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. [. . . ]