User manual ZANUSSI DCG310X

[. . . ] Save these instructions and make sure they remain with the machine if it is moved or sold, so that everyone using it through its life can be properly informed on appliance use and safety. Installation and servicing s All installation and service work done on the product s If you take any dishes out of the machine before the must be carried out by a qualified technician. Work performed by persons with inadequate knowledge may adversely affect the satisfactory functioning of the product and may cause personal injury or damage. Before any work is carried out on the dishwasher, it must be isolated from the electrical supply. To do this the power plug must be removed from the wall socket. s Water connection shall be made via an easily accessible end of the dishwashing cycle, it is extremely important to rinse them thoroughly under running water to remove any remaining detergent. s Do not place sharp knives with their points upwards. It is much safer to lay them horizontally in the basket. s When finishing loading or unloading close the door, as an open door can be a hazard. s Make sure that the machine is disconnected from the stopcock. s The power cable must be plugged into an earthed power supply during cleaning and maintenance work. s After using the machine, turn off its water supply and socket, which must be easily accessible. [. . . ] Ordinary domestic salt will affect the efficiency of the water softener and damage it. Remove the funnel and wipe off any spillage. The salt container holds about 1 litre, which is enough for about 20 - 30 dishwashing cycles. Always ensure that there is water in the salt container before filling salt. Cleaning the cabinet Wipe the outside of the cabinet and control panel regularly with a soft damp cloth. When necessary, use liquid kitchen or household cleaner to remove stubborn marks, rinse with a damp cloth and rub up with a soft duster. Never use abrasive cleaners which could damage the surface, ie: scouring pads or solvents (acetone, trichloriethylene, etc). If the machine is not going to be used for some time, take the folllowing precautions: 1. Unplug the machine and turn off the water supply. Make sure the tub is clean by carrying out a wash programme (without any crockery) using Finish Dishwasher cleaner, then dry the inside thoroughly. Leave the door ajar. Water softener plug (7) As supplied from the factory, the water softener is set for a water hardness of up to 20°dH. If your water is harder than this, you can increase the capacity of the water softener by pulling out the rubber plug at the rear of the dishwasher on the left hand side viewed from the back. · China with a pattern applied on top of the glaze may not be suitable for machine washing as the colours may fade and lose their lustre. The same applies to cutlery with wooden or plastic handles. Make sure you always buy articles that are dishwasher proof. · Not all plastic articles are machine washable. If you are in doubt as to whether your plasticware can be machine washed, we suggest you check by washing a single item or else wash them by hand. · Aluminium becomes dull and tarnished when machine washed. The machine gets it clean, but at the expense of its appearance. · When washing delicate items, select the lower wash temperature. · Substances such as ketchup containing strong colouring agents can cause temporary discolouration in the machine. 1 2 Instruction for test centres Test standard: Rated capacity: Loading of rack: Test program: Detergent (IEC type B): Rinse aid (typ III): Feed water pressure: Waste water outlet: EN 50242 5 place settings According to figure 1 Normal 65° C (+ Extra Drying) 15 gram in the dispenser Setting medium Minimum 0, 8 bar, maximum 10 bar Install according to figure 2 The salt container and rinse aid dispenser shall be filled in accordance with the instruction manual. Have the dishes not been arranged properly?Has anything prevented the spray arm from rotating? [. . . ] The manufacture is not responsible for any frost damage. - 13 - Installation The dishwasher is intended for installation on a kitchen sink or worktop. It is important to ensure the dishwasher is level to avoid any difficulty opening and closing the door. Its height can be adjusted with the adjustable feet (8 mm each) in each corner of the dishwasher. Water inlet The dishwasher should be permanently plumbed into a separate cold water supply. The water pressure must be within the limits given in the technical specifications, as it will not function correctly if pressure is outside these specifications. [. . . ]