User manual ZANUSSI DE4654

[. . . ] DISHWASHER DE 4654 GB Instruction book Attention The appliance which you have just bought is supplied not only with this instruction manual, but also with a Warranty Card Certificate, on the back of which are written the relative conditions. Please fill in the necessary details on the Card Certificate and send it to the Zanussi Centre relative to the area in which the appliance is to be installed, within twenty days of the date of purchase. Carefully read this instruction manual and follow attentively the recommendations it provides, and thus benefit from years of excellent service. The appliance which you have just purchased has been very accurately controlled throughout the entire manufacturing process. [. . . ] Characterised by a duration of about 30 minutes and a washing temperature of 60°C. The time value is approximate and depends on the pressure and the temperature of the water and also by the variations of the power supply. This is the perfect daily programme, made to meet the needs of a family of 4 persons who only wish to load breakfast and dinner crockery and cutlery. *** Testing programme for EN 50242 (see "Hints for Test Centres). 15 Operating sequence 1. Check the filters Ensure they are clean and properly positioned (see "Maintenance and cleaning"). 8. Setting and starting the programme Press the push button corresponding to the wanted programme: the indicator light corresponding to the programme illuminates and the phase indicator lights foreseen for that programme start flashing. Select, if required, the half load option. 2. Press the On/Off push button The On/Off indicator light will come on. 3. Check that there is rinse aid and salt The corresponding indicator lights will illuminate if refilling is necessary. The start of the programme will occur after about 6 seconds from the last pressure of a push button (programme or half load push button), in this time it is possible to change programme simply pressing the push button of another programme. Once the programme has started the phase indicator lights will turn off except for the phase under way. It is possible to interrupt the programme: q q 4. Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. Slide the baskets back into the machine. opening the door pressing the On/Off (in this case all the indicator lights turn off) Close the door again o press the On/Off, the programme will start from the point in which it was interrupted. 5. Ensure that the spray arms can rotate freely. Measure out detergent Add the required amount of detergent into the dispenser according to the recommended quantity given in the Washing programmes chart. If the half load option is selected remember to reduce the quantity of detergent. Close the detergent dispenser lid. 9. To cancel a programme in progress A programme in progress can be cancelled at any time. Press for about 3 seconds the push button of the running programme until all indicator lights are off. Only the On/Off indicator light will remain on once the programme has been cancelled. It is now possible to select a new washing programme. 7. [. . . ] Hooked over the edge of the sink using the special curved plastic guide provided. To a stand pipe provided with vent-hole, minimum internal diameter 4 cm. The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. The drain hose can face either to the right or left of the dishwasher Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water. Ø 18 max 100 cm CS09 Ø 18 Ø 21 max 100 cm + 2 m max CS10 If you use a drain hose extension it must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided. [. . . ]