User manual ZANUSSI DF62-26

[. . . ] This information has been provided in the interest of your safety. You MUST read it carefully before installing or using the appliance. q This product should be serviced by an authorised service engineer, and only genuine spare parts should be used. Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. [. . . ] The marking indicates the dosing levels: 20 = approximately 20 ml of detergent 30 = approximately 30 ml of detergent Special advice When using combination products, the rinse-aid and salt indicators are no longer useful. It may be helpful therefore to switch the rinse aid off (please note that only some dishwashers have this facility) and select the lowest possible setting for water hardness. For more information please refer to the instruction manual. If you decide to turn back to the use of the standard detergent system we advise that you: q Refill both the salt container and rinse aid dispenser. q Switch the water hardness setting to the highest possible position and run a normal washing programme without a load. q Readjust the water hardness setting again according to the hardness of the water in your area. DE19 DE22 3. All programmes with the prewash need a little amount of detergent (5 g) to be added in the adjacent chamber (3). Close the lid and press until it locks in place. Fill with detergent (Detergent dispenser type A) 1. If the lid is closed: open the dispenser by pulling the catch (D). Fill the detergent dispenser with detergent. The marking indicates the dosing levels: Min = approximately 15 g of detergent Max = approximately 30 g of detergent Concentrated detergent Based on their chemical composition, dishwasher detergents can be split into two basic types: - conventional, alkaline detergents with caustic components. Calgonit System includes Calgonit detergent, rinse aid, salt, machine detergent and Citro-Fresh. It is able to fulfil the main requirements for clearing both the crockery and the machine itself. 28 Starting a washing programme 1. Check that the baskets have been loaded correctly and that the spray arms can rotate freely 2. Press the On/Off push button The On/Off indicator light will come on. 7. End of the washing programme The dishwasher will automatically stop and the end of programme phase indicator light will illuminate. The indicator light of the programme just ended will remain on. The dishwasher has finished the programme only when the end of programme indicator light is illuminated. If you do not wait for the end of the programme it will not be possible to start a new programme until the previous programme has been cancelled. (For instructions on how to cancel a programme see the corresponding instructions). If during the drying phase (drying indicator light illuminated) the dishwasher door is opened or the On/Off push button is pressed, the running programme is automatically cancelled and the machine returns to setting mode (in this case it is possible to select a new programme without cancelling the previous) Switch off the dishwasher by pressing the On/Off push button, the On/Off indicator light turns off. Hot steam may escape from the appliance when opening the door immediately after the end of the programme, therefore, open the door carefully. 5. [. . . ] The sink plug must not be in place when the machine is draining as this could cause the water to siphon back into the machine. If you use a drain hose extension it must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided. Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided. Water inlet hose with safety valve After connecting the double-walled water inlet hose, the safety valve is next to the tap. Therefore the water inlet hose is only under pressure while the water is running. [. . . ]